2002 hundai Santa fe
Don't waste your money on unnecessary sources and unwanted repairs. Get this manual online at www.reliable-store.com and get complete guide
on whether to repair or not, service it, and how to repair etc
Do the doors lock normally when using the manual switch on the dirver's door panel? If so, the problem is in the ETACS module. Here's the wiring diagram:
SOURCE: how to remove alternator on 2002 hyudai santa fe 4 cylinder
try these websites to see if they have your car listed www.autozone.com and the other one is www.alldatadiy.com and if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car.
SOURCE: windshield washer on my 2002 hundai santa fe not
hi is there a noise coming from the washer when operated. it is posible there is a blockage in the tank at the pump intake. some windscreen wash additaves have a habbit of forming a heavy gunk. always use the liquid type. if there is no noise it is possibly a blown fuse or a faulty pump.
SOURCE: I need instructions to program keyless entry remote for 2002 Hundai Santa Fe
For a
1994 to 2006 Sonata, a 2001 to 2006 Elantra, a 2000 to 2006 XG350 or a
2001 to 2006 Santa Fe, you will need to access alarm system control
module. On most of those vehicles it is located on the driver's side
fascia panel. But on the Sonata, the facia panel is in the center.
SOURCE: I have a 2002 hundai santa fe 2.4l with p00113 code,How to check intake air tempeture sensor?
Before I give you my answer I need to advise you, if you have an aftermarket/performance air intake, it will trip an IAT code pretty often, you will either have to live with it or try to find a "dummy" sensor (a fake IAT sensor designed for cold air intakes that will make your engine computer think the incoming air is a certain temperature) if you dont have an intake:
Chances are if the IAT code is coming up (assuming you do not have a cold air intake system) your IAT sensor is probably bad. There is a very long and tedious process of testing the sensor and the circuit for the sensor, but with the average price of a new IAT sensor being around $12 I pretty much always suggest just replacing the sensor. On your vehicle the IAT is part of the mass air sensor assembly, but can be replaced independanlty, and shouldn't be a very difficult replacement.
Well, you basically have only 3 choices:
1. Pay the fee at the dealership
2. Purchase the high-dollar equipment that is required to perform the programming procedure
3. Forget about adding another key fob to tor vehicle.
TECHNICAL SERVICE BULLETIN
Group
90 - ELECTRICAL
Number
03-90-020
Date
October, 2003
Model
Elantra 2001-2004, Santa Fe 2001-2004, Sonata 2002-2004, Tiburon 2003-2004, XG(NNN) NNN-NNNNand XG(NNN) NNN-NNNN2004
Subject
SECURITY SYSTEM KEYLESS ADAPTER CABLE
This bulletin supersedes TSB # XXXXX
DESCRIPTION:
The security system keyless adapter cable (SPX/Kent-Moore P/N 09900-21300) is a special service tool (SST) that is used for programming new keyless entry remote transmitters to the factory security systems. The keyless adapter is used in conjunction with the Hi-Scan Pro (with Hi-Scan SOL Pro Software Version 09-29-03 or newer) and Data Link Connector (DLC) Cable.
SERVICE INFORMATION:
The keyless adapter cable can be used on the following vehicles:
^ 2001 -2004 Elantra
^ 2001-2004 SantaFe
^ 2002 - 2004 Sonata
111 views
Usually answered in minutes!
×