How do I replace a broken lugbolt on the front wheel of a 2000 ford escort?

SOURCE: How do I replace a camshaft position sensor on a 2000 ford escort

bullshits, the CMP sensor is near the 4 injector, you have to take out all the electric conector near injector 4, take out the 2 screws that hold the fuel rail, sometimes you have to take out the 4 injector for the space, then take out the screws that hold the CMP, lub the o´ring of the new one and reverse this steps.

SOURCE: front wheel bearing

Service and Repair

1. Remove front hub/steering knuckle assembly from vehicle.
2. Position front hub/steering knuckle assembly on a press and press front hub out of steering knuckle using a suitable removal tool.
3. Remove E-clip from steering knuckle, then position steering knuckle onto a press.
4. Using a suitable bearing remover, press bearing out of steering knuckle.
5. Reverse procedure to install.

SOURCE: belt diagram 2000 ford escort

Hi!

Please check this out---


Please rate this solution and ask for any clarifications if needed.

Thanks
Rylee

SOURCE: grinding noise in front wheel just changed pads not pads

sound like front wheel bearings badly worn.

SOURCE: how do I replace a 1998 ford escort front brakes

THIS IS FREE INFORMATION...FROM WF Pads Removal

1. WARNING: Asbestos fiber dust may be present on brake and clutch assemblies and is hazardous to health if inhaled.
   
   Brake and clutch assemblies should be cleaned using a vacuum cleaner recommended for use with asbestos fibers such as brake/clutch/service vacuum. The bag must be labeled per osha instructions, sealed, and the trash hauler notified as to the bag's contents.
   
   If a vacuum suitable for asbestos is not available, cleaning should be done wet. If dust generation is still possible, technicians should wear government-approved toxic dust purifying respirators.
   

1. Raise and support the vehicle.
2.Remove the wheel and tire assembly.
3.Remove the W-spring.


4.Remove the M-spring.

5.Remove the disc brake caliper locating pins (2B296). 6.Remove the front disc brake pads and shims from the disc brake caliper (2B120).

7.Compress the caliper piston completely into its BORE NOTE: Apply a thin layer of Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A Motorcraft WA-10 or equivalent meeting Ford specification ESE-M1C171-A to both sides of the perforated shim only.