SOURCE: how do I check the transmission fluid of my 98 Isuzu trooper ?
In fact, you can. The large transmission pan has two plugs in the bottom. The higher one is a fill plug. The lower one is a drain plug. The proper procedure for checking the level is: A) Drive vehicle until transmission reaches operating temperature (go for a 30 min drive). B) Park vehicle and apply emergency brake, run gear selector through all gears (engine running, pausing 5 sec.'s in each gear) from Park, down, and back to Park (very important to be in park when checking level). C) Immediately remove the upper fill plug and check level with your finger, it should be just up to the hole, fill as necessary. NOTE: If more than a dribble of fluid drains out when you first open the fill plug then it was overfilled or the procedure was not followed. Use a catch pan under the hole just in case. Filling of the fluid is by means of a small pump and hose, commonly found at auto parts stores.
SOURCE: 1998 Isuzu Trooper Shop Manual
The 1998 Isuzu Trooper is identical to the 1996 & 1997 Troopers with the 3.2L V6 motor. Chilton-Haynes have a decnet and detailed manual for this car. It's available on Amazon.com. That's where I got mine!
SOURCE: Where is the fuse box and relay box located on a
Hi , there are two boxes one is in the engine bay over the n/s wheel arch and the other is by your left foot in cabin .
SOURCE: how do i remove cv axle for a 98 isuzu trooper
Go to my profile I have just explained how to change a cv boot on a Trooper. The axle needs to be taken out to change the boot so the same solution. What you call an axle I have refered to as a drive (short for driveshaft) It takes a lot of explaining so save me a lot of writing if you read the solution I gave for changing the CV boot. Cheer's
106 views
Usually answered in minutes!
×