P1705 2-4 Brake Pressure Solenoid Valve (Solenoid D) Circuit
Testimonial: "Looking for procedure to ohms check"
http://www.gearsmagazine.com/magazine/su...
Comments limits ability to insert a hyperlink.
This is a nice article on Subaru transmissions and may not be 100% applicable to yours but the idea is the same. It lists the line pressure (and all the others) as 5.7ohms.
Thanks Much
×
SOURCE: needdrive belt diagram for Subaru outback 3.0
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: My 1999 subaru parking lights will not turn off
the rocker switch on top of your steering column is on.
SOURCE: I have a 1999 Subaru Outback Impreza Sport. The
If you have any of the large chain auto parts stores in your area, call them and ask if they do free scans; most do.
If Subaru has maintained the same procedures for a while, and you have checked fluids, etc., you can try resetting the light via the ignition switch:
-Turn on the ignition (don't start)
- switch it rapidly between the 'ignition on' and 'ignition off' positions three times.
If the error has cleared itself (not uncommon), the check light will reset. If the problem is still present, it will either stay or come back on.
Our Su has done this a couple of times and with the scanner we have on hand, there was never any particular repeated problem.
Just a computer glitch/hiccough -
SOURCE: NOISE IN THE FRONT LEFT WHEEL ON A 1999 SUBARU
if the front brake pads,rotor and more importantly the caliper were all installed correctly, this noise is probably a front hub bearing that is failing. they will start a humming noise and then a roaring/growling noise the worse they get. is the noise rotational? by that it will get louder and higher in pitch as you increase the vehicle speed. get it checked out right away to avoid possible further damage.
SOURCE: 1996 Subaru Outback Engine Code P0170
P0170 Fuel Trim Malfunction (Bank 1), could be fuel filter, mass air sensor, or low fuel pressure.
172 views
Usually answered in minutes!
×