Wiring, schematic, electrical diagrams, fuse diag, error codes, torque settings etc are basic contents of these online books they have here on this website www.reliable-store.com
I have attached. Must check it out
SOURCE: thermostat in a 1997 hyundai elantra
See exploded view
REMOVAL
1.
Drain the coolant down to thermostat level or below.
2.
Remove the coolant outlet fitting and gasket.
3.
Remove the thermostat
SOURCE: Location of the Purge Control Valve for 2003 Hyundai Tiburon
There were two different engines which were installed in the 2003 Tiberon... the 2.0 liter 4 cylinder:
And the 2.7 Liter V6:
SOURCE: 2003 Hyundia Tiburon BCM
http://www.newtiburon.com/forums/showthread.php?t=102241&highlight=bcm
SOURCE: oil control valve
on the lower front of the cyl head right where the thermostat is a 14 mm bolt remove that bolt and there will be a screen filter for the ocv if clogged it will reduce oil pressure to the ocv and give you a p0010 or p0011 code clean screen replace clear code all should be good
SOURCE: 2003 Hyundai Elantra - diable alarm
YES!... with various system operating difference. Disconnecting the alarm does not disable it.. it only silences the alarm. You will still need the Keyless Entry System Remote to RESET the alarm to start the vehicle.
The facia has several 'clips' which pop loose when you pry it out.
As you can see, there are four (4) screws in the environment control module. Reassembly is in reverse order.
320 views
Usually answered in minutes!
×