I have a 2000 dodge intrepid 2.7 with trouble codes p1684 and 0622 but already replaced battery and alternator still won't stay charged???

SOURCE: 2000 dodge intrepid 3.2 engine light on yesterday, code PO432

this is the code for catalytic convertor efficiency. if you decide to change the 02 sensor change both of the sensors for the left head...there is a good chance the convertor is going bad also depending on the miles

SOURCE: Replacing alternator in a 2001 Dodge Intrepid

the easiest way is going to first be to remove the serpentine belt which requires you to loosen the nut on the end of the idler pulley just above the alternator, then behind the pulley is a bolt with a 13mm head on it that you will want to loosen after the pulley is loose to relieve tension off the belt. Remove the belt. Next make sure you remove the battery cables to ensure you dont fry yourself to the car when unhooking the electrical connections from the alternator, your battery is located on the passenger side, down behind and underneath the headlight. Then go under the car and remove the black plastic clips that hold the splash shield up under the bumper. After this the alternator becomes as accesible as it can be, remove it from the bottom. Thanks for using fixya!!

SOURCE: Charging problem on 1996 Dodge Ram 3500 Cummins Turbo Diesel

I had the same problem on a 94 dodge with the cummins. It seems the crank sensor that reads from a notch on the harmonic balancer was the problem Without this sensor reading that the engine is running the alternator wont charge. Possibly the same problem with yours

chitownbob45

• 316 Answers
• Posted on Oct 15, 2009

SOURCE: how do you replace a coolant air bleeder on 2000 dodge intrepid

unscrew it out of the thermostat housing and screw a new one in. make sure cars not hot when you do this.

SOURCE: 2000 Dodge Intrepid / need help to replace front map dome light.

how do u turn interior light of with door open?