SOURCE: 1998 Chevy S10 pickup backup lights don't work
Yes it screws in on right side of tramission and you will need a 7/8 inch deep socket to remove it. You may be able to clean the old one once it is removed. There is a little ball thatgets dirty and may you can get by with cleaning it. Good Luck. Ed
SOURCE: 1988 Chevy S10 Durango Pickup, Won't start will fire
sounds like ignition module inside of distributor cap under distributor rotor button.these do go bad and can easily be replaced.strong suspicion from your details that this is the culprit.
SOURCE: Chevy S10 Pickup Starter. Removed the two bolts
Just changed a starter in a 94 S10 4x4. The only way to remove the starter was to take the passenger side exhaust manifold off and bring the starter out that way. Installation the same in reverse. Hope this helps. Don
SOURCE: transmission on my 2000 chevy k2500 4x4 pickup
your transmission has possibly been rebuilt with stronger springs put in. No worries. have been running mine for along while without any problems. Better this than slipping, but it is a bit annoying.
SOURCE: firing order for a 1999 chevy s10 pickup
I apologize for the late response...Due to the bad economic situation this site has had a substantial (+50%) increase in the number of questions being asked in the last four months.
I assume you have a 4.3L and not the 2.2L?
For the 4.3L:
Firing Order:
1-6-5-4-3-2
Cylinders:
6-----------5
4-----------3
2-----------1
(front of vehicle)
Distributor:
coil wire-->
-----6------->............<--------5-------
-----4------->............<--------1-------
-----2------->............<--------3-------
............(front of vehicle)
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!
63 views
Usually answered in minutes!
×