I plugged an accessory in aux 2. both quit at same time. fuse seems to be okay
SOURCE: 2005 colorado pulled fuse for power locks, to stop
This is a common problem, there is either a pinched wire in the harness that is in the door jam or your fuse block is shot, there is a gm service bulletin out on this, I would call your local dealership to find out if it is covered.
SOURCE: my 2005 chevy colorado wipers quit working and
check for bare wires associated with the wipers..u might have a simple short out problem
SOURCE: winshield wipers quit working. fuse is okay
debe cambiar los carbones o escobillas del motor del limpia brisas, para lo cual debe desmontarlo o removerlo de su lugar.
SOURCE: Fan does not work on
Give direct power to fan connections and see if fan runs.Connect 12 volt motor to fan and give power to motor via battery and see if fan runs.If the fan runs, then its faulty blower motor and it has to be replaced.---------
Also you can test blower motor as follows :----
place a test light or voltmeter in the wires going to the blower motor. If the light comes on or you have a 12 volt reading, the resistor and wiring are okay and the blower motor is faulty. This can also sometimes be confirmed by bumping the blower motor with the switches on. If the motor starts after bumping the motor is faulty.
---------------
Its not resistor fault, because when resistor fails, the fan still works on high speed.But in your case fan is not working at any speed.So resistor getting faulty is rare.But still in some cases the resistor and its connector gets slightly burned and that causes the problem.The burn on connector is sometimes neglected and that causes the problem.-------------
To see how the resistor and its connectors gets burned out.Click this link below:----
http://howtobyme.blogspot.com/2011/09/blower-motor-fan-not-working-on-2005.html
---------
This will help.thanks.Helpmech.
1,882 views
Usually answered in minutes!
×