SOURCE: where is throttle position sensor located on 2000 honda passport
Normally attached at opposite end of throttle linkage. Remove your air cleaner intake hose at throttle body, and observe throttle plate that opens & closes as you press accelerator, it will be at the end of that, on outside of housing.
SOURCE: Cam Shaft Position Sensor 1998 Saturn SL
Have a look at this link, scroll to your engine & click on picture to expand for better view.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528017e904
SOURCE: Where is the cam shaft position sensor located?
It's not that hard to replaced, and can be done with common tools.
3.4 camshaft sensor removal:
Remove the serpentine belt, Disconnect the sensor wire harness, Remove the power steering pump (just remove it from the mount and out of the way), Remove the attachment bolt to the sensor, Remove the sensor, (note spray around the sensor with brake parts cleaner before removal to keep dirt from entering the engine)
To install:
Lubricate the new O ring with engine oil before installing the new camshaft sensor, Tighten the retaining bolt to 8 ft.lbs. connect the sensor's electrical wire, reinstall the power steering pump, reinstall the serpentine belt.
Start the car and go out for the night with the money you just saved, You can pick up the camshaft sensor at Auto Zone and they can also give you the step by step instructions to getting the job done. Good luck and hope this helps. Take's just under 1 1/2 hour to do. You can do it in under 1 hour though if your good with tools.
SOURCE: 2000 Daewoo. Lanos won't start. What are the cam shaft positions
both lobes on number 4 cylinder face each other (point towards centre of engine)when timming marks on cam gears are lined up
82 views
Usually answered in minutes!
×