I have a 2018 odyssey ex-l w/ nav & RES. The dealer had to replace the transmission control module due to a misfire issue. That issue seems to be resolved but i now have an issue with the display audio. When car is cold the system takes up to 5 mins to turn on, then seems OK. Any thoughts?
SOURCE: 2001 Honda Odyssey Transmission Problem
The Odyssey has notorious bad transmissions from 2000-2003. You will not get anything on a trade, the trans can be fixed for about $2k. If everything else on the van still works and you like it, figure you bought it again for $2k. I changen my wife's Odyssey trans at 175K miles for $2k and she is happy so therefore I am happy too :-)
SOURCE: 2000 Honda Odyssey - P1739
P1739 Automatic Transaxle Concernsthis is from the Honda manual, what does this mean? it means there is an electronic shift solenoid fault in the transmission and it need to have the Honda dealer hook up there dealer only test equip to pin down the exact issue with the trans controls.
SOURCE: p0740 code on 2000 Honda Odyssey
Code p0740 is a problem in lock up control solenoid assembly, Check whether scan tool indicates another code. Does the scan tool indicate another code? YES - Perform the Troubleshooting Flowchart for the indicated Code(s). Do not continue with this troubleshooting until the causes of any other DTCs have been corrected. Measure the line pressure. Is the line pressure within the service limit? Repair the hydraulic system as necessary. Replace the Lock-up Control Solenoid Assembly set lock-up control solenoid valve/shift control solenoid valve A assembly and the A/T clutch pressure control solenoid valve A/B assembly. Turn the ignition switch OFF, and reset the PCM memory by removing the BACK UP fuse in the passenger's under-dash fuse/relay box for more than 10 seconds . Using the scan tool, check to be sure that the engine coolant temperature is 176°F (80°C) or above . Drive the vehicle at 55 mph (88 km/h) for more than one minute . Recheck for code P0740. Does the OBD II scan tool indicate code P0740? YES - Remove the torque converter and inspect for a missing torque converter O-ring. If the O-ring is damaged or missing, replace the transmission and torque converter. NO - The system is OK at this time.
SOURCE: Honda Odyssey won't start - flashing dashboard lights
Try a jumpstart. Can you honk the horn or use any electronics in ACC mode?
SOURCE: Our 2005 Honda Odyssey had a check engine light / misfire
When a cylinder mis-fires there is a reason. The dealer should have told you that. Most likely you have a fouled out spark plug. Which means you need new spark plugs and maybe wires. All this would be covered in a standard tune up. Once the bad spark plug is replaced, the computer will quit registering a mis-fire. Please give good ratings, they meen a lot to us.... Thank you
70 views
Usually answered in minutes!
×