You have faulty brake light switch... Could be located near pedal or by master cylinder.. don't know that model
That most likely is the brake lights staying on because the brake light switch under dash is out of adjustment and the brake pedal is not touching the button to shut it off. Possibly the spring is disconnected that pulls the pedal up against the brake light switch button. Check this out.
SOURCE: 06 pt cruiser wont start unless i roll start replaced cable from battery to fuse box
a bad starter or starter relay could cause this problem
SOURCE: daytime running lights
Check the relay for the daytime running lights - probably stuck on ya.
My 94 didn't have them, so I can't tell you where it is.
Somebody on here will know....
SOURCE: tail lights wont come on
two places left drivers side under the dash are on the side of the dash by the door for the interior, some cars have them on the right side of the dash also. There is also another fuse box under the hood. If you have your owners manual this is all listed in it, and the exact fuse location for your breaklights, I think your will be on the drivers side interior Hope this helps you! Merry Christmas and God Bless!
SOURCE: how to factory wire fog lights on a 2000 ford
This is a common problem on 97-00 MY trucks, regardless of the trim level ( XL, XLT, Lariat ).
If you install the fog lamp fuse in the BJB ( aka Battery Junction Box, Engine Compartment fuse panel ) Fuse # 9 ( 15 A fuse ) and jumper the normally open contacts in the fog lamp relay socket ( see diagram below ) the fog lamps should illuminate ( to confirm what you have doing on ).
The problem usually is the main headlamp switch to the BJB is not in place ( this is the yellow wire from the main headlamp switch connector to the relay socket pin #1 ).
One easy route is to make an aux lighting relay & harness, or purchase one online. With this, you can cut the factory ends and attach them to the harness you purchased. There is an air inlet next to where the steering wheel column runs through the firewall. This would give you an easy route to the fog lamp switch. The fog lamp switch, you can buy the factory one, and change the yellow wire from the connector to your added relay, or just add a switch for this function.
This will give you an idea of what the DIY relay and harness would look like.
Hope this helps, more than confuses at this point
SOURCE: 1999 Subaru Forester Where is fuse for electric
you may find the fuse diagram on the inside of the fuse box cover, try looking under the dash there might be another fuse box there.......hope this helps....cheers
94 views
Usually answered in minutes!
×