SOURCE: How to find and change a hyundai elantra automatic transmission filter
no filter,has a bolt on the botton of transmittion oil pan,unscrew drain oil for about 10 minutes put back the plug and refill from the check oil stick ciao
SOURCE: trans drops into 3rd gear won,t shift to 4th
DTC P0734 is "4th gear incorrect ratio" - that's your torque converter 'LOCK UP Clutch" It's worn out (or you're using the wrong Trans Fluid required by Hyundai - SPIII OR Both). The P1624 is simply the Trans Control Unit (computer) communicating to the Engine Control Module (ECM computer) MIL - on request signal to ECM = asking it to turn on "Check Engine" light. MIL = Malfunction Indicator Lamp. When the torque converter 'lock up" clutch slips or doesn't engage, the trans automatically returns to 3rd gear and stays there (it's called 'fail safe' mode) until you cycle the ignition key, then everything resets until the malfunction occurs again.
You'll need to have an AT (Automatic Transaxel) tester hooked up to verify this. Hyundai has a Service Bulletin specifically for "gear incorrect ratio' codes. If when you changed the trans fluid, was it done at a Hyundai Service Center? If not, someone may have installed the wrong fluid.
SOURCE: change tke hood realase cable in hyundai elantra
Service and Repair Notes HOOD LATCH CABLE REPLACEMENT Remove the following items: Hood release handle. Radiator guard. Hood latch. Wheel guard. Using a clip remover, detach the clips from the body, then remove the hood latch cable (A) from the vehicle. NOTE: Take care not to bend the cable. Installation is the reverse of removal. NOTE: Make sure the hood latch cable is connected properly. Replace any damaged clips.
SOURCE: Describe your is there a sensor on a 2000 hyundai
YES!... There are many sensors on an automatic transmission which could pose a problem -- depending on what the problem actually is. For example, there are 'input' and 'output' speed sensors, there is a fluid temperature sensor, there is a vehicle speed sensor, and there are several solenoid valves located inside the transmission connected to the valve body. Each and every one of these items can be a problem -- again -- depends on what the problem ACTUALLY is. Agreed?
SOURCE: 2000 Hyundai elantra transmission delay, reverse going
Did you check the transmission fluid level? If necessary, add fluid. However you probably have a more serious problem. Take the car to a qualified transmission mechanic.
99 views
Usually answered in minutes!
Is it very costly or can I convert to Manuel. Thanks for reply
×