Question about 2000 Lincoln LS

Open Question

How to install fuel filler door lid release handle actuator on 2000 ls lincoln?

Posted by on

Ad

5 Suggested Answers

Anonymous

  • 4 Answers

SOURCE: fuel filler release doesn't seem to work

i also have a 94 tercel with this problem. the spring is missing so i tied a long shoestring to the release lever next to the seat. i hold the string and it pulls up on lever while i use my key to open the door the rest of the way. the door pops open enough for the key to fit in the crack. hey it works for me lol have tried to find another spring at wrecking yard but someone always beats me to it

Posted on Oct 03, 2008

Ad

Anonymous

  • 2 Answers

SOURCE: 2000 lincoln ls inside door handle not wrking

I had the same problem. Buy the handle from the dealer and I can tell you how to replace it.

Posted on Oct 22, 2008

Ad

Anonymous

  • 8 Answers

SOURCE: Fuel Filler Lid won't open

it sounds like you have a broken cable that connects from the inside of the car to the release of the gas tank. now the other release ( you said the book says is in the trunk on the lefthand-side ) it is probably under the lining of the trunk because most of them are not in plan sight for you to see.

Posted on Mar 24, 2009

Anonymous

  • 1 Answer

SOURCE: Cant open fuel filler door,where is the switch?

I have a 97 and there is no release for it. Just push on the right end of the gas cap door to open it. Hope that helps.

Posted on Apr 16, 2009

Anonymous

  • 1 Answer

SOURCE: S70 remote fuel filler flap not opening , Help needed urgently

My mechanic says this can be due to a brainshort on the part of the onboard computer; if the original driver's side doorlock switch goes on the fritz, it can confuse the computer and mess up the fuel door switch, trunk switch, and even the driver's door key switch (opening twice doesn't unlock the other car doors) - all of which happened on my car.

Posted on Jul 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel door won't open on a 2008 g8 pontiac


Fuel Fill Door Description and Operation
The fuel door latch actuator shares the circuit with the driver door latch assembly. The body control module (BCM), upon receipt of a lock switch lock or unlock signal, will switch the appropriate door lock actuator, as well as a fuel filler door release actuator control circuits to battery positive voltage. The opposing side of the door lock and fuel filler door release actuators is connected to ground by the I/P fuse block through the other door lock actuator control circuit and the doors, along with the fuel filler door release, will lock or unlock as commanded.
Circuit/System Testing
  1. Ignition OFF, disconnect the harness connector at the fuel door release actuator.
  2. Test for less than 1 ohm between the control circuit terminal 1 and ground.
  3. ?‡'
    If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance.

  4. Test for less than 1 ohm between the control circuit terminal 2 and ground.
  5. ?‡'
    If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance.

  6. Connect a test lamp between the control circuit terminal 1 and control circuit terminal 2.
  7. Ignition ON, command the doors to LOCK and UNLOCK by using the door lock switch. The test lamp should illuminate while commanding the LOCK and UNLOCK states.
  8. ?‡'
    If the test lamp remains OFF during either command, test either control circuit for a short to ground.

  9. If all circuits test normal, test or replace the fuel door release actuator.
Component Testing
  1. Ignition OFF, disconnect the harness connector at the fuel door release actuator
  2. Install a 15A fused jumper wire between the control terminal 1 and 12V. Momentarily install a jumper wire between the control terminal 2 and ground. The fuel door release actuator should perform the LOCK/UNLOCK function.
  3. ?‡'
    If the function does not perform as specified, replace the fuel door release actuator.

  4. Reverse the jumper wires. The fuel door release actuator should perform the UNLOCK/LOCK function.
?‡'
If the function does not perform as specified, replace the fuel door release actuator.


Remove the rear compartment side trim (right) panel. Refer to
Rear Compartment Side Trim Panel Replacement .

Apr 06, 2016 | Pontiac Cars & Trucks

1 Answer

Fuel door for 2002 lincoln LS won't open. Unable to find release inside the trunk and the fuses all test good.


the release is in trunk on the same side as the filler door. pull it and open the door

Sep 15, 2013 | 2001 Lincoln LS

1 Answer

Thank you for your response , been going crazy here...got panel off enough to put hand in but don't know where to pull to unlock door.



Jaguar 2000-06 - Locks & Lock Systems
Power Door Locks - Removal & Installation

Door Lock Switch
Door Lock Diagnosis & Testing

  1. Visually inspect the following:
    Misaligned door(s), hood or luggage compartment lid Door latches Actuating rod Exterior door handle Interior door handle Door lock cylinder Cable Luggage compartment lid exterior release switch Fuse(s) Wiring harness Electrical connector Door lock actuator Remote transmitter batteries Vehicle battery Remote transmitter Door lock switch Front electronic module
  2. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.

Door Lock Motor
Coupe And Convertible
  1. Turn ignition key to position II.
  2. Motor door glass to fully raised position.
  3. Turn ignition key to position O.
  4. Disconnect the negative battery cable.
  5. Remove door casing for access.
  6. Remove door water shedder.
  7. Position PVC secondary water shedder for access.
  8. Slacken and remove the door glass rear runner lower securing screws.
  9. Reposition door glass rear runner. Mark the position of the glass rear runner upper securing screw.
  10. Slacken and remove the upper securing screw and move the runner away from the glass.
  11. Disconnect door handle and lock barrel (driver door only) operating rods from latch links.
  12. Slacken and remove the three latch assembly securing screws and position latch for access.
  13. Remove latch motor harness multiplug from mounting bracket and disconnect multiplug.
  14. Release operating cable from door handle. Move inner door handle to the locked position. Remove operating cable outer abutment from support bracket. Disconnect cable inner from door inner handle.
  15. Remove lock motor assembly from door.
  16. To install, reverse removal procedure.

    zjlimited_378.jpg

    Fig. Removing door lock actuator


Sedan
  1. Remove the door window glass
  2. Detach the interior door handle.
  3. Detach the actuator remote cable from the interior door handle.
  4. Remove the interior door handle.
  5. Detach the door window glass run.
  6. Remove the exterior door handle retaining screws.
  7. Remove the front door actuator retaining screws.
  8. Reposition the front door actuator and exterior handle.
  9. Remove the front door actuator and exterior handle.
  10. Disconnect the front door actuator remote cable.
  11. Detach the door lock cylinder connecting rod (1).
  12. Detach the exterior door handle connecting rod (2).
  13. Remove the front door actuator (3).
  14. To install, reverse removal procedure.

    zjlimited_379.jpg

    Fig. Removing door lock motor-Sedan



Hope this helps.

Dec 31, 2010 | 2002 Jaguar X-Type

1 Answer

2002 Lincoln LS Fuel Filler door will not open when I press the button inside car? How do I repair


check for a blown fuse. open trunk and there should be a pull handle on left side.

Aug 21, 2010 | 2002 Lincoln LS

2 Answers

Air conditioner blowing hot air


Blowing hot air when set to A/C is almost always a stuck blend door, dead blend door actuator, or a cracked or disconnected blend door actuator vacuum line. The blend door is inside the a/c ducting under the dash, but the actuator will be accessible outside the ducting.

Jul 05, 2010 | 2000 Lincoln LS

1 Answer

Is there a manual release for the fuel tank door on a 02 lincoln town car?


There should be a manual release in the trunk. Sometimes it's hidden behind the carpet panel, but it will be near the trunk lid or near the gas tank lid on the interior of the trunk.

Oct 25, 2009 | 2002 Lincoln LS

1 Answer

Fuel door release will not open


  • Remove fuel tank filler cap.
  • Push back release rod - 9 - by operating remote control unlock and remove bolt - 2 -.
  • Remove rubber part - 8 - from tank filler flange and swivel out tank flap unit - 1 - from side panel - 7 -.Assembly piece - 4 - and actuator - 6 - is installed.
    • Install tank flap unit - 1 - (rubber part rolled up) with hinge side first.
    • Bolt tank flap unit - 1 - and assembly piece - 4 - with bolt - 2 -.
    Tightening torques: Bolts - 2 - 1.5 Nm
    • Remove side luggage compartment trim.
    • Disconnect harness connector at actuator - 6 -.
    • Remove actuator - 6 - using special tool Socket wrench T 10010 from angled mounting bracket.
    • Remove actuator - 6 - together with release rod - 9 - from seal - 5 - and assembly piece - 4 -.
    Installing
    Installation is reverse of removal.
    Tightening torques: Bolts for actuator - 6 - 1.5 Nm .
  • May 27, 2009 | 2001 Volkswagen Passat

    2 Answers

    Fuel Filler Lid won't open


    it sounds like you have a broken cable that connects from the inside of the car to the release of the gas tank. now the other release ( you said the book says is in the trunk on the lefthand-side ) it is probably under the lining of the trunk because most of them are not in plan sight for you to see.

    Mar 24, 2009 | Hyundai Motor 2003 Sonata

    2 Answers

    Fuel filler door won't open when release is pressed 1998 Lincoln


    should be an emergency cable to pull inside the car behind the filler cap

    Jan 13, 2009 | 1997 Mazda MX-5 Miata

    3 Answers

    2000 lincoln ls inside door handle not wrking


    I had the same problem. Buy the handle from the dealer and I can tell you how to replace it.

    Sep 13, 2008 | 2000 Lincoln LS

    Not finding what you are looking for?
    2000 Lincoln LS Logo

    Related Topics:

    46 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Lincoln Experts

    Marvin
    Marvin

    Level 3 Expert

    85223 Answers

    gerry bissi

    Level 3 Expert

    4388 Answers

    Jonah Oneal

    Level 3 Expert

    14092 Answers

    Are you a Lincoln Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...