I am not car machanics please don't send this prob
If you hit the Rev Limiter on a Ford, it will simply bounce the rev back down, to protect the Engine. So, no high Revs. But, you should be able to bring it slowly to a High RPM. That is normal. If there are no Check Engine Light on. You are most likely hitting the rev Limit and need to stop.
SOURCE: 2001 jetta wont rev past 3,00 rpm
I believe you are still out of timing. pretty close, but not there yet. review all the steps.
SOURCE: 1997 ram 1500 5.9 wont rev past 2000 rpm
well, the timing on your ram is computer controlled. is the truck in drive when this mis-fire occurs? or at idle? youve addressed part of your ignition w/the cap-rotor-plug wires. did you examine the old cap for carbon tracking? did you install the rotor properly? i know on my '97 ram the dist is feakin' buried in the engine it would be easy to rotate the rotor while installing/removing it so the timing mark is off. does your engine have the right plugs installed? your plug wires follow the correct firing order with your dist? you did not mention anything about your ignition coil. here is how to safely remove and check your ignition coil. disconnect battery-at the coil disconnect the lead wire (TOP) and primary (BOTTOM) from the coil. label your wires, or take a pic of your ign coil before you remove it so if you forget where the wires go, you have reference point. remove mounting screws and remove coil. clean coil to remove rust/dirt and wipe coil terminals off. inspect case for damage. with a multi-meter, check coil primary resistance by selecting ohm's and then place + and - leads on the pos/neg terminals on the coil, dodge used 2 brands of coils either a "diamond" or a "denso" primary resistance for the diamond mfr'd coil will be between 0.97-1.18 ohms. secondary resistance 11,300-15,300 ohms. Denso primary resistance 0.95-1.20 secondary resistance of 11,300-13,300 ohms. to measure secondary resistance place one of the leads to one the primary terminals and the other lead attatch to the large center terminal. compare your readings to the above values. if your readings are not within range of the above values, your problem is the ignition coil. other causes you may consider is faulty: speed sensor, throttle pos sensor/trans issues like bad pressure solenoid (actuates gear changes) a fault in your overdrive system. hope i have helped!
SOURCE: 2005 ford freestyle surges while foot on brake
Its a common fault with the fords.The air throtle idle valve needs to be replaced.Or you may call it a tapper valve.
SOURCE: where is the ac port for charging my 2005 ford freestyle
It is located to the passenger side firewall near the strut tower. There is a solenoid on top of it.
SOURCE: do I need to change transmission fluid on my 2005 ford freestyle
The high pressure filter and fluid are supposed to be changed at 60k intervals. Ford has a very specific oil for this transmission and the service fee will be $300 to $450 - mine was around $420.
No other car place will touch the CVS transmission in a Ford Freestyle and most Ford dealerships are clueless on thier maintenance and repairs. On most issues that crop up the first thing they want to do is swap it out - for $4000+.
1,457 views
Usually answered in minutes!
×