Cars & Trucks Logo

Related Topics:

b
bruce topham Posted on Dec 12, 2017

How do i remove rear seat back on ford f250 extra cab

5 Related Answers

freetek

Steve Allison

  • 5569 Answers
  • Posted on Nov 23, 2008

SOURCE: remove back seat

In most cases, the factory installed rear speakers are accessible through the trunk, not behind the seat. Open your trunk and check if you can see them by looking up and forward in the trunk opening.

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 02, 2009

SOURCE: Install Rear Speakers Ford F150 1997 Regular Cab

you should not have to remove the panel by taking the four phillips screws out of the speaker grill you will pull out through front

Anonymous

  • 437 Answers
  • Posted on Jun 06, 2009

SOURCE: I have a Ford F250 Extended cab that started Running Rough

P0301 = Misfire cylinder #1P0303 = Misfire cylinder #2
P0171 = System too lean cylinder #1
Are you sure on the P1151 code? I am thinking this may be a P0151 which is O2 sensor related.
This looks like you have a fuel system related misfire. I would do a fuel injection cleaning service and then clear codes and see if the codes regenerate.

Anonymous

  • 10319 Answers
  • Posted on Feb 14, 2010

SOURCE: how do you remove rear hub on ford f250 3/4 ton

hub is on the axle shaft so the center cover will have to be removed to remove the c ring that keeps it in place. then remove the axle shaft having the wheel and drum off first

Anonymous

  • 155 Answers
  • Posted on Feb 26, 2011

SOURCE: how to remove bottom section

there should be a couple of bolts one on each side on the floor in front of the seat bottom remove and get in car put your hands down between the top and bottom seats and lift hard

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do you remove rear brake rotors

If you have to ask--well--!!

You Tube Video & watch how
0helpful
1answer

Haw to gat out seat back

Rear Seat Backrest-SuperCab Removal
  1. Fold down both rear seat cushions.
  1. Remove the rear seat back.
    1. Push the wire hooks rearward to disengage the seat backrest from the back panel of the cab.
    1. Lift the rear seat back upward and remove.
    a0015238.gif
Installation
  1. Align the upper hooks with the upper brackets on the back panel of the cab.
  1. NOTE: Make sure the safety belt webbing is not twisted.
    Route the rear center safety belt through the retainer ******** the rear seat back.
  1. Place the lower hooks behind the lower brackets on the back panel of the cab.
  1. Lower the seat back until the lower hooks engage the lower brackets.
  1. Verify all three upper hooks have engaged the upper brackets
1helpful
1answer

My drivers side heated seat doesn't heat up anymore but the light on the switch lights up

this sounds like a bad heating element in the seat, you will need to test for power and ground at the connection going to heat element, if theres power and a good ground then the element is bad, you will need to remove the seat and take the covering back to remove element.
0helpful
1answer

Does the rear seatback fold down in a Ford F-150 extended cab?

The 04-08 MY changed to a bottom of the seat folds up, where the 03 and older where the seat back folded down.

Do you need to remove the seat back ?
0helpful
1answer

How to take out rear seats in a 2000 ford f250 lariat

crew cab,use a 50 torx in front bolts ,15mm on a ratchet on back bolts slide seat belt buckles throu seat crack ,fold rear of seat down ,lay seat with hinge toward floor slide out door (note watch brackets ,will scratch door pannals)
3helpful
1answer

Does my rear seat fold down in my 2006 ford f-150 ext. cab

Seat bottoms fold up.

You can remove the rear seat back, if that is what you are looking for. Just post a comment back.
1helpful
1answer

How do I put the front right rotor back on the spindle after a wheel bering replacement? I can't get it on far enough to get the spindle nut on. 2003 F250 2WD

Make sure you remove all the rust from the spindle and rotor. Make sure the bearing races are all flush. Use a rubber mallet,not a hammer
to properly seat the rotor. Good luck.
0helpful
1answer

How do you remove rear hub on ford f250 3/4 ton pick up

hub is on the axle shaft so the center cover will have to be removed to remove the c ring that keeps it in place. then remove the axle shaft having the wheel and drum off first
Not finding what you are looking for?

3,764 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...