Code p 430 refers to catalytic converter system , bank 2---efficiency below threshold ====causes ---cat converter--wiring ---Heated oxygen sensor (HO2S in the exhaust manifold bank 2 before the cat converter)
have the cat converter checked for failure and blocking the exhaust
SOURCE: where is the o2 sensor located on a 1991 honda accord ex 2.2 engine
Further clarification on the O2 sensor location: It is in the exhaust pipe, under the center of the car, on top of the pipe, just aft of the oil filter.
SOURCE: 1998 honda accord obd code P0171 and P0170.
Hi,welcome to fix ya.
p0171 is for a lean fuel condition .A variety of things can cause this code the most common one is a bad o2 sensor but a plugged injector,fuel filter or dirty egr system can cause this as well.
SOURCE: 1991 honda accord - runs rough and stalls on start up.
Did you set the ignition timing after you installed the dist.? If yes, I'd say you got a bad distributor(the one you just put in) since all the codes you're getting are directly for sensors located within the distributor.
SOURCE: honda accord ex 2001 check engine light suddenly came on, car started to idle roughly
If it's running rough, chances are that it's misfiring. If the Check Engine light is flashing/blinking, it is definitely misfiring.
If that's the case, drive it as little as possible... Or straight to the mechanic because the more you drive it while it's misfiring, the higher the chance is of you ruining your catalytic converter.
I’m happy to help further over the phone at https://www.6ya.com/expert/jason_00b31cc8f593773a
108 views
Usually answered in minutes!
×