Need to reset oil change light on nissan quest 2001

SOURCE: Resetting the oil change monitor in the information centre after an oil change

With the van on, (it does not have to be running.) press the maint button untill the oil miles is showing. Hold down the maint button untill it resets. You can also press the joystick over left or right to set the amount of miles between oil change. Trip reset should do the same as well for the oil and tires.

Marvin

• 85242 Answers
• Posted on Apr 02, 2009

SOURCE: reset change oil soon light 2001 saturn L-200

Under the hood, next to the battery, is a fuse box. Lift the lid (instructions are on the lid) and with the keyswitch on but the engine not running, press and hold the button that says "oil". The book says 5 seconds, but hold it for about 10. If someone is watching the dash lights while you do that, the change oil light should flash briefly.

SOURCE: 2001 brake pad replacement 2001 nissan quest

The hard part is pressing the caliper piston abck into the caliper so you can get the new, thicker pads over the rotor. A large C Clamp works best.

SECTION 206-03: Front Disc Brake 2001 Villager Workshop Manual
REMOVAL AND INSTALLATION Pads —Front Disc Brake Removal

1. Remove the wheel and tire assembly. For additional information, refer to Section 204-04 .

1. Remove the front disc brake caliper bolts. torx bit. T20?

1. Support the front disc brake caliper from the front strut and spring assembly using mechanics wire.

1. Remove the front disc brake pads.
   1. Remove the outboard front disc brake pad.
   1. Remove the inboard front disc brake pad.

1. CAUTION: Make sure the master cylinder reservoir does not overfill and spill brake fluid while retracting the front disc brake caliper piston.
   NOTE: It is necessary to fully retract the front disc brake caliper piston in the bore before installing the front disc brake pads.
   Install the front disc brake pads.
   1. Install the inboard front disc brake pad.
   1. Install the outboard front disc brake pad.

1. Position the front disc brake caliper on the front-wheel knuckle and install the brake caliper pin bolts.

1. WARNING: It is necessary to depress the brake pedal several times to position the front disc brake caliper piston before driving the vehicle.
   

SOURCE: Hows to reset oil light and oil filter light on 2007 nissan altmi

maintenace and oil filter. i got an oil change last month on my 2007 nissan altima and they did not reset the mileage so the lgiht on the leyboard came on and I cant fix it

SOURCE: reset change oil light

hello, here is the instructions on how to reset the light

When the system has calculated that oil life has been diminished, it will indicate that an oil change is necessary. A CHANGE ENGINE OIL SOON message will come on. Change the engine oil as soon as possible within the next 600 miles (1000 km). It is possible that, if driving under the best conditions, the oil life may not indicate that an oil change is necessary for over a year. However, the engine oil and filter must be changed at least once a year and at this time the system must be reset.
If the system is ever reset accidentally, change the engine oil at 3000 miles (5000 km) since last oil change.
To reset the Engine Oil Life System, do the following:

1. Turn the ignition to ON, with the engine off.
2. Slowly fully press and release the accelerator pedal 3 times within 5 seconds.
The reset is complete when the chimes sound and the CHANGE OIL lamp goes out. If the lamp stays on and no chime is heard, repeat the reset procedure.

3. Turn the key to OFF.