Question about 2006 Hyundai Tucson

Open Question

Where to find oil control valve filter on hyundai tucson 2 L 2006

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 2 Answers

SOURCE: oil control valve

on the lower front of the cyl head right where the thermostat is a 14 mm bolt remove that bolt and there will be a screen filter for the ocv if clogged it will reduce oil pressure to the ocv and give you a p0010 or p0011 code clean screen replace clear code all should be good

Posted on Jun 22, 2009

Ad

marley mcelhinney

  • 490 Answers

SOURCE: The type of motor oil for my Tucson

just go to where ever u were planning to buy the oil from and tell them what type of car, make and year it is and they will give u the correct type

Posted on Nov 04, 2009

Joe Hogan

  • 10865 Answers

SOURCE: Replace Hyundai Tucson cabin filter

hi. here is the link to the step by step.

http://blog.aggregatedintelligence.com/2007/12/hyundai-santa-fe-cabin-air-filter.html

Posted on Jul 29, 2010

anjy834u

  • 869 Answers

SOURCE: engine light on in hyundai tucson even after

check for lose connection on ur tucson. if the issue persists, then take it to a dealer.

Posted on Jan 28, 2011

rotagen

  • 17 Answers

SOURCE: HOW TO CHANGE FUEL FILTER ON 2008 HYUNDAI TUCSON

instructions

Things You'll Need:
Fuel-line disconnect tool
Rag
New gasket
New fuel pump
Flat head screwdriver
Ratchet and socket
The assistance of a friend (only when you are ready to remove the back seat)
Rubber hose plugs
Two adjustable wrenches
1

Locate the fuse panel under the hood of your vehicle, then open it and remove the fuel pump fuse with your hands.
2

Start your car and allow the fuel system to depressurize by allowing the car to idle until the engine dies.
3

Reinstall the fuse, then disconnect the battery with a ratchet and socket. Drain the gas from the gas tank with a siphoning kit.
4

Remove the back seat by unbolting the base with a ratchet and socket and lifting the seat out with your hands. The bolts are located on either side of the seat near the base. You will also need the assistance of another person to lift the seat out safely.
5

Remove the wiring harness by gently pulling it from the connector, and detach the rubber grommet with a flat head screwdriver. Unbolt the fuel tank cover with a ratchet and socket, remove it with your hands, pull the wires through the grommet, detach the fuel line hoses with a fuel-line disconnect tool, and lift the hoses out. Cap the hoses with rubber hose plugs.
6

Reach directly into the gas tank, then remove the fuel filter using two adjustable wrenches, placing one on either side of the fuel filter. You will recognize the fuel filter by its filtering paper cartridges.
7

Install the new filter, then follow the previous steps in reverse to complete the installation. Refill your gas take when finished

Posted on Feb 10, 2011

Testimonial: "thaks Question: why I need a new fuel pump ? its necesary to change fuel pump too ? thanks again"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission filter on 2006 Hyundai Tucson need to be changed do you have to change filter


It's a good idea. The filter keeps particles from the clutch plates from entering the valve body. The damaged valve body is expensive.

Apr 16, 2017 | 2006 Hyundai Tucson

2 Answers

Where is the oil pressure sender switch located on hyundai tucson


Your best bet is to buy a service repair manual specific to your vehicle since you'll want to make other repairs when they arise. You can purchase hard copies in book form or download an electronic version. Such publishers for automotive repair manuals include Motors, Chilton, Haynes, etc.

Feb 23, 2017 | 2008 Hyundai Tucson

2 Answers

2013 hyundai tucson will not idle and stalls out.


Check the throttle body bore and plate for carbon buildup. Possible vacuum leak also.

Feb 08, 2016 | 2013 Hyundai Tucson

1 Answer

What parts do you recommend for a fault on my Hyundai Tucson which has developed faults?


uh oh, 1186 and 0087 are both related... fuel pump or the filter or both! either case the filter is now located inside the fuel tank

P1186 Hyundai Fuel Pressure Too Low


P0087 Fuel Rail System Pressure Too Low

"Potential causes of a P0087 trouble code may include: Weak fuel pump, clogged filter or screen, restricted fuel supply line Faulty fuel pump driver module Faulty fuel pressure sensor"


How to Change the Fuel Filter on Hyundai Tucson eHow

according to eHow, you can access the filter relatively easily. (although the pic is an illustration of something not really related to this ~ why they showing a fuel petcock that's not even on your car?)

P2112 Throttle Actuator Control System Stuck Closed

"Possible causes:
- Throttle Body Plate Binding
- Faulty Throttle Actuator
- Throttle Actuator harness is open or shorted
- Throttle Actuator circuit poor electrical connection"

older models we had the gas pedal attached to a cable to move the butterfly valve on the throttle body. Now it's this newer drive-by-wire stuff... remove air intake hose and check / clean / move the throttle body valve by hand first to see if it's binding or not

then, go from there on testing the actuator and tps

Apr 17, 2015 | 2006 Hyundai Tucson

1 Answer

Hyundai tucson crdi


You might have an air lock in the fuel system. The lines from the injector pump possibly need broken loose at the injectors and cycle the fuel pump several times until nothing but pressurized fuel comes out.

Jul 26, 2014 | 2006 Hyundai Tucson

1 Answer

INEED TO KNOW THE LOCATION OF THE OIL FILTER FOR A 2005 HYUNDAI


Forward on the engine, left hand side. Since the Tucson has a engine 'under-cover' shield, the shield must be removed to access the oil filter (5 12mm bolts & two plastic spread retainers).

Sep 01, 2011 | 2005 Hyundai Tucson

2 Answers

2007 tucson 2wd 4 cyl.oil leaking - starter is covered in oil.don't think it is valve cover.any suggestions?


get it fixed. then get the shop to clean off the starter. oil is not good for electrical parts.

Nov 16, 2010 | 2004 Hyundai Tucson

1 Answer

Hyundai Tucson


The transmission filter is inside the transmission. You have to drain out the oil and remove the transmission pan and gasket. The filter is made of metal guaze and is screwed/bolted to the underneath of the valve body.

Apr 08, 2009 | 2005 Hyundai Tucson

Not finding what you are looking for?
2006 Hyundai Tucson Logo

Related Topics:

670 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...