Question about 2003 Oldsmobile Silhouette

Open Question

Replacing oil pressure sensor 2003 oldsmobile sillouette

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 512 Answers

SOURCE: how to replace oil pressure sensor

its on the rear of the engine next to the distributor

Posted on Dec 04, 2008

Ad
GM Elec

Bruce Bracey

  • 1000 Answers

SOURCE: Where is the fuel pressure regulator on a 2003 oldsmobile alero?

There are 2 fuel lines connecting to the fuel injector rail. The larger line is the pressure line and the smaller line is the return line. The smaller line attaches to the fuel pressure regulator. You will notice that the regulator also has a vacuum line attached to it. If you are planning on changing it your self, let me know. There is a specific way to change it for safety reasons.
Let me know.
Regards,

Posted on Mar 10, 2009

Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: Where is the oil pressure sensor on a 2001

The oil pressure sensor is between the exhaust manifold and oil filter. You can get to it better from the bottom by removing the oil filter to give you more room and it should take you under 30 min to replace oil filter and all. I guess if you have long thin arms you can get to it from the top too. Good luck and hope this helps. 

Posted on Jul 03, 2009

honeymokey

honeymokey

  • 3113 Answers

SOURCE: Pontiac Bonneville 2003 oil pressure 120/// and maf sensor code

Replace oil pressure sensor. What is the code?

Posted on Aug 12, 2009

Anonymous

  • 1 Answer

SOURCE: 1996 oldsmobile aurora oil pressure

The Aurora is a low pressure oil system. The only solution available at this time is to increase the oil weight. I went o straight 30W to solve the idle alarm issue. Some use 20W oil and that works too.
With 20W you will be at 80 to 90psi cold then drop to 20-30psi hot.
I first replaced the oil pressure gauge and it was worse. I put the original back in and it was better. Then went to 30W and all is fine.
Running it that way for a few years now.

Posted on Apr 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is a 2003 oldsmobile alero 2.2L engine oil level sensor located?


most if not all are visible from Oil Pan , you will have to search fom under neath car with good flashlight . Often wires become heat damaged cracked /oil soaked or The O Ring sealing unit to Pan Leaks = = False reading . But reason to trigger code / trouble light is often due to heavy footed acceleration when engine is actually low on oil . Be sure to unplug Negative battery cable 30 minutes to reset code reading - - YOU May Not Need New Part if reset clears code now that oil is FULL or if recently changed all newer GM models must have a reset to tell %#$@$$&^$$$ computer oil was changed . ...Hope above helps save $$$ by not installing new part ..

Nov 28, 2014 | 2003 Oldsmobile Alero

1 Answer

Where is the oil pressure sensor on my oldsmobile aurora?


On the right side of the vehicle is the oil filter box next to the filter is the oil pressure sensor.---------------------------------------------------------------------------------------
Lexia-3 V47

Feb 26, 2013 | 1999 Oldsmobile Aurora

1 Answer

2003 Dodge Neon Check Oil light wont go off. Car has oil-full, and just put in new Sensor.


Do you mean the oil level sensor was replaced, or do you mean the oil pressure sending unit was replaced?
If it was the oil pressure sensor was replaced, then I would look into an oil pump going bad, not supplying enough pressure to the oil pressure sensor. This can be tested by putting an oil pressure gauge into where the oil pressure sensor normally goes, bypassing the circuitry that leads to the dash light for the oil pressure.

If it was the oil level sensor, then check for bad wiring.

Oct 26, 2010 | 2003 Dodge Neon

1 Answer

What should oil pressure be at idle.Does the read out on your dash always right.


my 4.0 reads 18 PSI at idle, but on the 3.5 versions I have a lot of bad oil pressure sensors. They end up reading very high or go off scale at the top. Replacing the sensor fixes it only for a short time. I finally gave up on it.
Should probably read 40 -60 PSI driving.

Jul 08, 2010 | 2003 Oldsmobile Aurora

2 Answers

LOCATION OF OIL PREASURE SENDING UNIT ON 3.4 ENGINE


The oil pressure switch is just above the starter.

Dec 06, 2009 | 1998 Oldsmobile Silhouette

1 Answer

1997 olds sillouette running low on coolant -


If it is just low now it may just be age and needs to be flushed and changed. If the problem is always there and you are not over filling the system cjheck your overflow. Also pressure test the system for leaks don't just look. Check it under pressure, leak may be very slow and will only show up under pressure. Also if all that checks fine watch for white smoke coming out of the tailpipe. That will indicate coolant in the exhaust.

Sep 28, 2009 | 2002 Chevrolet Impala

1 Answer

Where is the oil pressure sensor on a 2001 Oldsmobile Aurora with a 3.5 V-6


The oil pressure sensor is between the exhaust manifold and oil filter. You can get to it better from the bottom by removing the oil filter to give you more room and it should take you under 30 min to replace oil filter and all. I guess if you have long thin arms you can get to it from the top too. Good luck and hope this helps. 

Jul 03, 2009 | Oldsmobile Aurora Cars & Trucks

1 Answer

Program key fob 1999 sillouette


Take it to A GM Dealer they Hook into the ALDL and Reprogram it By Way of a Scanner

Feb 05, 2009 | 1999 Oldsmobile Silhouette

1 Answer

1996 oldsmobile aurora oil pressure sensor says low oil pressure my mechanic checked it out and replaced the oil pressure sensor and problem still exsists he tested the oil pressure recommended 20 PSI when...


The Aurora is a low pressure oil system. The only solution available at this time is to increase the oil weight. I went o straight 30W to solve the idle alarm issue. Some use 20W oil and that works too.
With 20W you will be at 80 to 90psi cold then drop to 20-30psi hot.
I first replaced the oil pressure gauge and it was worse. I put the original back in and it was better. Then went to 30W and all is fine.
Running it that way for a few years now.

Jul 17, 2008 | Oldsmobile Aurora Cars & Trucks

Not finding what you are looking for?
2003 Oldsmobile Silhouette Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

Jonah Oneal

Level 3 Expert

14092 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...