Cars & Trucks Logo

Related Topics:

S
Simone Cortinas Posted on Nov 14, 2017

Door light, radio, and automatic door unlock does not work on my 1994 MPV what could it be the van turns on but only when its on do all the doors unlock at the same time.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Dec 07, 2008

SOURCE: door locks

Daughter had same problem on '05 T&C. Neighborhood mechanic searched Internet and found 80-90 others with same problem right around 40,000 miles. Free solution was to pull yellow 20A IOD fuse in right front corner of fuse box under hood, wait 10 seconds, then reinsert fuse. Should solve problem as long as you don't lock doors with FOB. You can unlock doors with FOB, but apparently locking with FOB causes the problem.

Permanent solution is to have dealer reprogram computer for around $50 which is what my daughter chose to do because of inconvenience of not being able to lock doors with FOB when getting baby/carseat out of vehicle.

Ad

Anonymous

  • 137 Answers
  • Posted on Feb 02, 2009

SOURCE: Automatic door locks will not work.

you need to take it to the dealer and have them check the bcm for codes.... also have them check to be sure you have the latest software in the bcm.. its possible that you just need a software update... there are several TSB's covering the concern you have..... it can be a very simple fix with software or even a stuck lock switch may need to be replaced... without the proper diagnostic codes being read from the bcm all that can be done is guessing..and that can be expensive...

Anonymous

  • 150 Answers
  • Posted on Feb 18, 2009

SOURCE: Radio, Key auto door lock/opener, interior lights not working.

Most likely is a fuse. There is a fuse box at the end of the right side of the dash. Open front passenger door and there is a cover that says fuses on the end of dash. There is also a fuse box located under the hood at the right front of engine compartment. It should have a cover with a round knob in the middle of it .Unscrew the knob to remove cover.

autotherapis

Rich Norman

  • 502 Answers
  • Posted on Aug 16, 2009

SOURCE: 2000 Astro van - drivers window only goes up a in increments

The motor is shot. It works a little and overheats, replace the motor . Same thing the the lock acuators. The are trying but have lost the power to move the locks. May as well replace them while the door is apart.

david dixon

  • 740 Answers
  • Posted on Mar 24, 2010

SOURCE: 2004 mazda mpv sliding door will not unlock from

sounds like the lock rod fell off. Take the door pannel off and reatach it

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

How to remove the stereo on a 1996 mazda mpv

Mazda MPV Dash Trim Removal, Stereo Removal - Auto ...

? 3:38
https://www.youtube.com/watch?v=REoTeVM2S-o
Jul 1, 2013 - Uploaded by Robert DIY
Dash trim removal: 5 minutes. This video will show you how toremove the dash trim piece on the Mazda ...

[PDF]MAZDA 1996-UP MPV - Scosche

www.scosche.com/media/guides/ma381.pdf
164. 1996-UP MAZDA MPV. MINIVAN. RADIO REMOVAL USING SCOSCHE DT-1 TOOLS . FRONT DOOR PANEL. FRONT AND REAR DOOR 61/2" 3-HOLE.

DIY Mazda Car Radio and Speaker Removal, How to Remove

www.carstereoremoval.com/htm/stereoremovalMazda.htm
'96-99* Car Stereo Removal · Ford Stereo Removal Tools Stereo Removal Tools. How To Install and Remove Mazda MPV Van Car Radio and Speaker, '89-95*
0helpful
1answer

Morning i have a 2001 mpv and i hooked the jumper cables backwards. Now the radio,door locks,and the interior lights don't work at all. I checked all of the fuses inside and outside the van.Is there a...

recheck the high amp fuses ie 100 amp as sometimes they blow but look ok best test with a multimeter with fuse out and twist contacts as you test them....
1helpful
1answer

I have a Mazda MPV 2001 van that two of the automatic windows have stopped working. Is this something that I can fix myself?

On my MPV the problem was actually the Switch not the motor. Check the switches. You can access them by just pulling the door panel off. If you need some instructions for door panel removal let us know.

Hope this helps...
0helpful
3answers

04' Ford FreeStar - The Radio Stay On When Van Is Off

Nothing wrong with it. When you remove the key, it stays on for about 20 minutes. It gives you time to finish listening to your radio and roll up the window. Once the driver door is open, everything shuts off or if 20 minutes has passed. 
 
 

0helpful
1answer

Radio, Key auto door lock/opener, interior lights not working.

Most likely is a fuse. There is a fuse box at the end of the right side of the dash. Open front passenger door and there is a cover that says fuses on the end of dash. There is also a fuse box located under the hood at the right front of engine compartment. It should have a cover with a round knob in the middle of it .Unscrew the knob to remove cover.
0helpful
1answer

Radio went out, door ajar light stays on lost manual for fuse box

Google the vehicle or you can ask the dealer what fuse is for a specific item or check each fuse 1 by 1.
0helpful
1answer

1994 T & C alarm (factory) goes off stops me from starting my Van

you can try a couple of things put the key in the drivers door lock manually lock and unlock the door
with it unlocked try starting the car if that doesn't work disconect the battery turn the key on then hook up the battery and try to start it also check your owners manual about the alarm
good luck!!
10helpful
3answers

Program remote control for mazda mpv 2002

Courtesy of: forums.mazdaworld.org

Try this, it works on several 2002 models:


Step 1: Open drivers door and leave open.

Step 2: Lock and unlock the drivers door using the power door lock switch on the door.

Step 3: Insert key into the ignition.

Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.

Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).

Step 6: ECU should respond by locking and unlocking the doors.

Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.

Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.

Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done
2helpful
1answer

Automatic door locks

faulty switch or relay or just a fuse
Not finding what you are looking for?

64 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...