On my 2002 Toyota Camry I asked about the blend door actuator earlier.The accuatorappears to be working. Vehivle doesnt over heat. But I still get no heat from the vents. Any ideas?

SOURCE: 2000 Astro van - vent

The problem is a 1/8 diameter hose that runs from the front of the engine over the top and connects at the rear of engine on the drivers side. It is a vacuum hose #GM15967970 It cost about $6.22 at your GM dealer. Hope this helps Bill. My E-Mail is [email protected]
This was posted on a problem with a 2002 astro, I do believe it is the same fix. A simple vacuum hose, It is difficult to route through the engine

Marvin

• 85242 Answers
• Posted on Sep 23, 2008

SOURCE: Blend door not working.

The bleed door controls air temp not where it comes out, dash, floor, defroster, this is most likely a mode control switch problem, that switch is on the ac control head.

SOURCE: Blend door not working.

check the vacuum supply and vac lines from the control head for a leak

SOURCE: blend door actuator needs replacing does the

no it doesnt ... check out heatertreaters.net if you have to replace the blend doors .... but the actuator is directly behind the glove box...remove the glove box take out 3 screws and remove actuator and replace.....waa laa

SOURCE: how to replace blend door actuator in a ford

I recently did mine, I hear you can do it without taking the entire dash apart but I had no luck with it myself. I have to get ready for work but, on mine it was located down and to the left of the radio. its a white box...are you hearing a clicking noise or something? I had to roll the entire dash back and it was still a major pain getting it out.