Hi, I need a dash wiring diagram with color codes for a 98 s10 2.2

Question edited for clarity.
Question moved to model category.

6 wire wiring

https://www.pirate4x4.com/threads/i-need-a-couple-schematics-fuel-lines-and-the-wiring-to-the-pump.1059343/

4 wire wiring

https://www.2carpros.com/questions/dodge-ram-1998-dodge-ram-fuel-pump-electrical-connection

https://www.google.com/search?q=1999+dodge+ram+1500+fuel+pump+wiring+diagram

..

These are the best sites for wiring diagrams. Some are subscription sites but you can take just one month cheaply.

https://www.google.com/search?q=1998+dodge+durango+door+locks+wiring+diagram

https://www.google.com/search?q=2003+dodge+durango+door+locks+wiring+diagram

..

If you are changing the engine the purpose of all those wires is a moot point. Most of them are for sensors and actuators that may or may not exist on the V8 and the 4 cylinder ECM will not run the V8. You need to find a wiring diagram, a multimeter and a jumper wire to make sure what wire is connected to what in the dash or you will be replacing all the wiring in the dash along with the printed circuit on the back of the instrument cluster.

Why do you need a wiring diagram for a O2 Sensor? They are 4 wires and when you replace the sensor, you get a OEM. If you are going to get a Universal, it comes with a wiring diagram (GREY go to WHITE) and Black to Black

Your talking about low oil pressure, not level, correct? Hope you can read diagram. The top wire, oil pressure sensor should be voltage and bottom wire is ground. Use digital multimeter on low voltage setting to check. The sensor sends signal to pcm, on the right in diagram, the dashed lines. Then the pcm sends data to instrument cluster on buss circuit.
I agree with other person, it could be low oil pressure and everything else is working correctly.

Hi, there is no power there per se, but there should be 2 wires. Both must run to the PCM. See diagram below for wire colors. The PCM is back against the firewall on the passenger side below the hood hinge.

That is an older car. A schematic may be available on a Google search. Chiltons and other repair manuals often do not have electrical schematics.

I HAVE NO MONEY CAN U PLEASE HELP ME

i think the ground wire going to the gauge is black/white stripe and solid black is pump ground the bigger gauge wires r pump wires and the smaller gauge wires go to the fuel guage

to do this job correctly you will need to uso a igntion and computer from a 318 truck . the v6 used a coil pac and the v8 uses a single coil this would be the best way to go and will save you a lot of problems later