SOURCE: Blown main fuse on 2003 mazda protege 5.
There are two bolts on the side of the fuse itself. Under the fuse box on each side. Unbolt those and it will come out.
SOURCE: how to adjust caliper for rear brakes on a Mazda Protege Es.
on the rear calipers there is a 14m bolt on the back of the caliper beside the parking brake braket.
remove bolt on the inside there is a hex screw. as you turn it the piston gose in or out.
check calipers for damage.
SOURCE: how to install fuel pump in chevy 2003 astro van
Go to the autozone website at autozone.com and register your vehicle. It's free and will give you access to an online repair manual for your vehicle. The procedures for changing the fuel pump should be available there. Sure hope this helped and best wishes.
SOURCE: where is the blower motor resistor on a 2002 mazda protege?
just remove the glove box and its right behind it just take the white pug out and the two phillips screws to remove the resistor out, replace with the new one and cool off!!!! Hope this helps
SOURCE: For 2003 Mazda Protege ES model 2.0L 4cyl engine;
Check the air inlet boot going from the air filter to the intake for rips or holes. If rips exist, this would allow air to bypass the filter and mass air flow sensor and will lead to a check engine light appearing. The code would read "too lean, bank 1." If this problem is allowed to continue for long periods of time, the EGR ports will have to be cleaned out and maybe even the intake.
300 views
Usually answered in minutes!
×