It cut off while in drive. guage on left (idle one) goes up and down like its struggling to not hit zero and cut off.
P0022 A Camshaft Position - Timing Over-Retarded (Bank 2)
P0345 Camshaft Position Sensor circuit malfunction
P0431 Warm-up Catalyst system below efficiency
A bad camshaft sensor or wiring to the the sensor would cause the other two codes. Since P0345 refers to a circuit issue, get the wiring diagram and check the circuit before assuming you have a bad sensor. If the circuit checks out, then consider replacing the sensor. After that, clear the codes and drive to see if they come back.
SOURCE: 2004 mazda MPv Where is the location of cyl. #6?
The firing order is 1-4-2-5-3-6. The cylinders are, front bank is from drivers side to passenger, 6-5-4 , and 3-2-1 at the firewall.
SOURCE: Engine shakes when Idling/ Check Engine Light started blinking
i just fixed a similar problem on my van there is a rubber elbow on the end of the pvc hose that connects to the valve cover you can only buy the elbow with the hose and it costs about 100 bucks but i guess they have had to replace a lot of these because the new one looks twice has strong you just have to check and see if its collapsed in on itself preventing air movement or leaking the shop will charge you 175 dollars to fix it plus the part but it only takes 20 minutes good luck
SOURCE: A 92 Mazda mx3 with a 1.8ltr v-6 while at an idle
change the idle air control motor and check to see if the ports are clogged, this too will cause surging idle. the idle air control motor is located on or near the throttle body
SOURCE: code po705 mazda protege lx shaking rough start
The Code you refer to is P0705 Transmission Range Sensor Circuit malfunction (PRNDL Input). It is a possiblility that because this code is present, this sensor is malfunctioning. If it is malfunctioning, that means the engine needs to "guess" the value that this sensor is responsible for. In most cases when this happens, the engine will go for a value that ensures the car runs. The engine will not try to run smooth or efficently, it will only try to run. It is my guess that if you have the sensor checked and replaced, the problem might be fixed. Please let me know if this answers your question and please rate my response. Thank you
Testimonial: "that is good. where is the trasmission range sensor circuit located "
169 views
Usually answered in minutes!
×