In old vehicles I would say follow the Positive cable from the battery to the starter. Look like this car is like my grandma sentra the starter is up top.
Hear is a link which I think may help.
https://www.justanswer.com/ford/4ii0s-ford-ford-escape-v6-2008-ford-escape-ottawa-area.html
SOURCE: 03 ford escape v6 find & change spark plugs
i also have a ford escape. the other three plugs are under the upper intake manifold. You have to remove this to change them takes about an hour in a half if you have some experiance working on cars
SOURCE: 2005 Escape starter replacement
take the negative side off the battery put the car on ramps secure the rear end so it does not roll and if you need a diagram for removing and installing the starter try autozone
SOURCE: ABS & traction control just went out on 2008 Ford Escape.
Chances are it is a bad ABS sensor. Need to get scanned to know for sure and which one.
Not much i know but I hope that helps.
SOURCE: How do you replace the EGR on a 2002 ford escape?
To replace the the spark plugs on the V6, you'll need to remove the intake manifold. There is a coil on top of each plug (COP). Check this website for info:
http://www.escape-central.com/1forum/showthread.php?threadid=32550&referrerid=11756
The same link will also show the R&R of the EGR valve.
SOURCE: 2008 ford escape. The climate
the problem is most likely is the blower motor resister.the info on the 08 this still limited. but i found this.
551 views
Usually answered in minutes!
It should be on the same side of the engine as the ac unit, just behind it.
×