How much would it cost for 100? - Cars & Trucks

Straight replacement cost including time $375 upwards

If they order the parts from rockauto its about $630-700 in parts. $50-60 front and rear brake pads, $ 100 -115 2 better front rotors, $100 for better rear rotors, $90 for each rear caliper, 100-125 per front caliper, $10 for each rubber brake line. (The caliper prices include a core fee that you would get back $30-40 per caliper returning the old caliper, but you pay the shipping fees). The ballpark prices also include the additional shipping costs. Labor should be around 2-2.5hrs. So depending on the shop it would be $50-60/hr so total cost $100-150 for the labor. So total would be somewhere around $730-850. You can just have the one caliper replaced, you do not need to replace them all. I would get new rotors on whichever axle (front or rear) the stuck caliper is on and not get the rotors cut, because the faulty caliper could have warped the rotor. Another possibility is that it could just need a new rubber brake line. When my calipers locked on one of my classic trucks, I just replaced the old rubber line and it was good to go. -Fawkes

Go to Autozone.com or Advance auto sign up to create an account. Once you select your vehicle you can acquire cost. These units are refurbished and usually cost around $100 to $150. If you want OEM you will need to pay much more.

Your car has a governor built in so it will limit the speed to about 100. Call a auto parts store for a correct price for a belt with make , model year and engine size.

You would have to shop around. Refurbished starters might run between $50 to $70. New ones $100 up. If you are having a mechanic do it, the repair cost for a 2 hour job might cost you $100 up. If you are to do it yourself, check with the internet. Complete easy installation instructions are availlable. Just type how to replace a starter on a 2004 Marcury Sable and print them out. Hope this serves you well and good luck with your project.

depends on the garage and what country your in as to the cost ,but i would charge the cost price for the belt about 100 euros for doing it

master cylender usally costs 50 bucks and most shops charge 1 hour labor, So right at 100, Now the Caliper costs a little more but still around 149 parts and labor

assuming you are talking about the accessory drive belt, this is the one that runs the PS and AC then...

about $100 for the part from the dealer and another $100 to install

maybe $50 aftermarket and you install it yourself

then of course you need to factor in the cost of the belt

Cost will be about 10x this if you are talking about the timing belt

Hi:
A new serpentine drive belt can be purchased for less than $30, and If you are paying a shop to install it, I would not think that it would cost more than $100 total cost, but you could call your service department and ask for a best guess estimate? Often, you can also price out the part at your local auto parts store too, as sometimes the dealer parts prices are some what inflated .

well it could be the gauge which means you may need a new instrument cluster, A couple hundred plus the diag charge. Say $300 or more easy.

Or it could be $100 for diag and $100 for maybe a speed sensor.

Or it could be $100 to $300 for diag if you have a broken wire somwhere