How to replace shift cable 2000 tarus - 2000 Ford Taurus

Have the oil pressure checked with a test gage, if it is ok then replace the oil pressure sending unit. I assume the oil level is good.

Your car has went into a fail safe mode, either one because the speedo is not the proper gear ratio for that particular vehicle, not all of them were the same, it depends on the exact model. For instance, a Tarus SE is different from a Tarus LE / SE / on and on, and if the gear ration is not correct, then the TCM will not ssend a signal to the shift solenoids to do their job thus the car wont shift. It sounds to me like your original issue may have been that the speedometer didn't function or work at the cluster, ad you've made repairs to the wrong part. Change your Spped Sensor, and it will be ok, IF the cluster is for that particular vehicle. If it is the proper part, your only issue is the speed sensor.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/samuel_4e847b1ae10ff587

The headlights are on separate circuits the only thing common to both sides is the on-off switch and the battery terminals

there is no linkage there is a cable fron the transmission to steering column nylon gromets on each end break replace shifter cable

nope 6 years parts will be different.

if you have to step on the brake to shift from park, it could be that interlock switch.

A/T Shift & Key Lock Control Module

then the transmission has failed or has sticking engagement solenoid in trans pan, have the fluid and filter replaced and see if that corrects the problem

check to see if there is power at the light green/red wire at the alt. If the is no power check the thirty amp fuse in the engine comp fuse box for the alt.

As long as they are the same displacement and have the same number of cams. Yes they share the same engines.