Question about 2004 Ford Focus

1 Answer

Hi replaced the drivers window reg and motor on my dads car last year and it worked fine .not it will not work or if it dose only some Times would you say needs an other new window reg and motor

It's a Ford Focus 04 plate

Posted by on

  • Liam
    Liam Sep 20, 2017

    What should the resistance be in a Ford focus window switch drivers side



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 3,952 Answers

Remove the door panel and use your voltmeter to see if it's getting power and ground. If it is, then you need a new regulator.
Replace window regulator Ricks Free Auto Repair Advice

Posted on Sep 18, 2017


6 Suggested Answers


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


ash seder

  • 166 Answers

SOURCE: groaning noise on my peugeot 306 passenger door/ cl unlock n locking thing

open the door pull the rubber boot back that houses the wiring loom you will find that there are a number of wires broken if doable solder them back to gether and insulation tap them up, you should find this solves your problem.
your noise should and your windows should work if there are to many wires brocken you can get a new loom from the dealer

good luck

this is a very common problem i do 2 ore 3 of these a day

Posted on Dec 20, 2008

Bruce Hunter

  • 23 Answers

SOURCE: Power window failure on drivers side

Sometrimes the wires between the door and the body break from opening and closing the door, check your window motor for paower with a test light, if no power, you have a broken wire, between the door and body

Posted on Jan 07, 2009

66 chrgr

mike loshbough

  • 1011 Answers

SOURCE: The heated seats don't heat, both driver and passenger side.

your heater element in the seat went bad,the dealer will have to do this because the seat has come apart the cover wether it is leather or cloth.

Posted on Jan 25, 2009


  • 8 Answers

SOURCE: How do I know if my drivers side power window is grounded properl

Hi there,
Try replacing the button that you push up and down. It could be bad under it and not making the connection. Maybe take the panel off and take the switch off, then clean the connecters under the button. Maybe that will do it. Also, you probably already ckeched this, but is the window off track? Well, good luck and let me know. Have a great night.~MWD

Posted on Mar 26, 2009


  • 37 Answers

SOURCE: driver side power window control dose not work


Posted on Apr 06, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Drivers side window does not work. all other windows work ok. Honda Accord Year 2000. tried different master switches but same issue. how can you tell if it is definitely a new switch required please?

if no switch operates the window will be the motor
or broken wire across the door hinge

can you hear a motor click or sound from the door
if not
take the door card off and hot wire the window motor
Part2 How to fix replace install broken window regulator motor Honda...

Jul 14, 2016 | Honda Cars & Trucks

1 Answer

Hi All, I have a W-reg (year 2000) 318i BMW and my air blowers are playing up. The temperature is fine, the blower speed is fine but the directional controls need repair. The screen and footwell blowers...

Most likely you have electrical control. Since you have defrost and footwell heat. So you have to replace the motor that controls the vent door. You can find the location online, as I don't have them.

Oct 08, 2014 | Cars & Trucks

1 Answer

The window on a honda civic dose not have enoght power to go up, but it goes down fast

hello, try new switch, these power window motors seldom go out, i just replaced power window switches on a astro van, this lady had not rolled pass side window down in 2 years, put switch in a started working fine, if that dont work, you might have to replace window motor, get them at junkyard for 50.00 dollars. put them in is a different story.

Feb 06, 2010 | 1998 Honda Civic

1 Answer

1995 Cutlass Ciera : Can check list to repairing power windows

the motor window is worn out which is common. You will have to remove all screws on door panel and then pry panel off. You will then have access to the motor. It may have soldered wires on it. Others can pull off, or you can cut wires up stream and twist back together later with new motor

Sep 14, 2009 | 1995 Oldsmobile Cutlass Ciera

2 Answers

Frozen power window

I just fixed a frozen up one on a 2002 Alero, I removed the door panel, unbolted the motor and it had a lot of pressure on it. When re-installed with no preload, the window worked fine. I lubed the tracks with silicone spray just to be safe.

I've seen this many times over the years on GM windows and still can't explain why it happens. Perhaps holding the switch in the up position too long/?

Feb 25, 2009 | 2000 Oldsmobile Alero

2 Answers

Power windows seem stuck

lithum grease the slides on the window don't forceit it has a plastic gear drive you can strip it . glass shop you my need new new window regulators beware not too cheap

Jan 03, 2009 | 1996 Plymouth Voyager

Not finding what you are looking for?
2004 Ford Focus Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides