Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Sep 16, 2017

Where is iac on 08 4runner v6 - 4Runner Toyota Cars & Trucks

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2003. Where is the idle (air) control valve?

Infiniti G35 2003, no engine told or vin and I tell you.
the IAC can be many places.
on side of TB or car is TBW? lets look
or bolted to the intake manifold anywhere.
3.5L V6 engine if USA =
answer there is no IAC the TB (twb) is now a virtual IAC, the PCM uses the motor drive in the TB to
control idle as do all newer cars do now.
also shopping for IAC this car shows no hits. (USA)
TBW = throttle by wire
TB = throttle body valve. TV= throttle valve, ASE names all.
1helpful
1answer

Got a 1988 oldscuttlass ciera v6 put new iac in run good for about 2 days now its back to dieing and popping

check plate between carb and intake possble shorting out you will notice wires going to it
0helpful
1answer

1993 chevy s-10 2.8l v6 tbi. replaced iac, tps, injectors. still idleing very high while warming up.

Honestly, I have a 1993 2.8 L V6 and it's always idled high when warming up. They're rather notorious for that for some reason lol
0helpful
1answer

I have a 1999 ford contour 2.5 v6 high idle excessive noise from iac and goes away on accel

I have teh same vehicle/engine and had the same problem. I replaced the IAC and have not heard the noise since.
1helpful
2answers

Can the 99 maxima idle air control valve fit a 2000 maxima

If you have the 3.0L V6 yes. If you have the 3.5l V6 no.

Hope this helps.
0helpful
1answer

CAMRY 89, V6, AUTO TRANS PROBLEM IS IDLE DROP SHAKING BAD WHEN ONLY PUT GEAR IN DRIVE, REVERSE, NEUTRAL, AND PARK NO PROBLEM, I HAVE CLEAN IAC VALVE WON'T GET BETTER, HOW FAR IAC VALE MOVE FROM OPEN TO...

If it were an IAC problem it would do it in reverse also. A bad engine mount can cause shaking in one direction but not the other, Also check your vacum hoses and lines.
0helpful
1answer

Where is the IAC Valve located on a 2006 Jeep Commander 3.7L V6 Car?

I also drive a 2006 Jeep Commander 4.7L V8. I can't seem to find anything that looks like an IAC. My rpm fluctuates in idle mode. What can I possibly do to rectify it without breaking the bank?
2helpful
1answer

Engine idle problem comes and goes but shows no check engine light.

4CYL or V6?? Clean/Replace your IAC valve as this will cause rough/erratic idles(may happen intermittedly). IAC valve motor possibly sticking due to dirt and carbon build-up. I also recommend a full tune-up, including air filter, and intake cleaning if this hasn't been done recently. Hopefully this helps....
2helpful
1answer

Low idle with vibration and turns off when in reverse of drive every now and then and stirring wheel feel like its going to lock when turnign but all fluids have been checked and ok battery and alternator...

4cyl or V6?? Start at cleaning/replacing the IAC valve(idle air control valve),MAF sensor(V6 only) and cleaning the intake. At this time, I recommend replacing the air filter and sparkplugs(if not done recently). The IAC valve may be dirty or defective causing rough, low, or no idle. hopefully this helps
Not finding what you are looking for?

63 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...