Lights are out on the passenger side and the blinker goes fast and the lights on the rear work but fast.. my dome lights don't work with doors either...only by switch on light...i have changed bulbs in front turn signal and then pulled back a part and cleaned sockets on the front and rear and used electrical grease on plugs....also pulled plug cluster on rear of vehicle on driver side and cleaned and grease them...still the same...any help would be appreciated!!
Circuit/System Description
Ground is applied at all times at G201 to the turn signal/multifunction switch. The turn signal lamps may only be activated with the ignition switch in the ON or START position. When the turn signal/multifunction switch is placed in either the TURN RIGHT or TURN LEFT position, ground is applied to the body control module (BCM) through either the right turn or left turn signal switch signal circuit. The BCM then applies a pulsating voltage to the front and rear turn signal lamps through their respective control circuits.
.
Did you check the RT STOP TRN fuse 15amp insturment panel fuse box.
Fuse Block - I/P
Left of the I/P behind the side trim panel
If the fuse is good , you could have a wiring problem or the BCM is bad .
SOURCE: Chevy Cavalier 2001 turn signal blinks fast
If new bulbs don't work, it is probably the harness that holds the bulb. I had to replace both on my car after fighting with the problem for over a year and not knowing.
SOURCE: front driver side turn signal light doesn't flash
replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block....probable bad driverside flasher
SOURCE: 2002 blinker light replaced works but sometimes
try replacing the tail lamp socket. it could be shorting out
SOURCE: Changed multi function switch, bulbs, and
You have a bad connection at the rear passenger side turn signal. It is either the connection is corroded or a wire is loose on the ground side of the circuit.
Testimonial: "Thank you so much!!! Good things be with you!!"
SOURCE: 1998 chevy S10 4x4 passenger rear turn signal and break light not working
I would try measuring for 12 volts at the socket while the turn signal is on.
149 views
Usually answered in minutes!
×