SOURCE: removing and fitting a new gear knob bmw e46 318i man trans
Hi joserosa if this is a manual gearbox you just have to grip the gear knob and pull upwards until the gear knob is removed, the same principle is applied for a auto box but hold in the release button while removing, regards Mark.
SOURCE: bmw 318i e46 idle bad
try disconnecting the air mass meter sensor if it runs better then ur air mass meter has failed had the same problem
SOURCE: removal and replament of a 3 Series BMW E46 1998 saloon wing mirr
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: i have a bmw 318i e46 and she keeps overheating
replace the header tank...common problem with these.....get from dealer, less than 100 quid....also check the cooling fan is working as this causes the tank to split if it is not....not so cheap and complex to repair
79 views
Usually answered in minutes!
×