Question about Plymouth Sundance

Open Question

My 1988 Plymouth Sundance gets hot and starts stalling when slowing down and the dies wait 10 mins starts up and drive for 20 mins and does it again have flushed and changed thermostat no leaks but

When its 60 degrees or lower out I don't get the stalling and dies

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Alex Werz

  • 72 Answers

SOURCE: 2000 2.0 vw shutt down after running 20 min

Replace the fuel pump relay, it's easy and cheap.

Posted on Jun 08, 2009

Ad

Jason Johnson

  • 1619 Answers

SOURCE: 88 pontiac 6000 shudders and stalls after approx. 30 min. driving

What was replaced in the tune up? Usually the coil paks cause these types of issues. Also fuel filter or fuel pump will allow enough fuel to start and sputter like you describe.

Posted on Jun 16, 2009

steven bruce

  • 422 Answers

SOURCE: will drive 1996 stratus about 20 mi. it dies wait and it starts

relay problem either the asd relay or the fuel pump relay is bad. now pay me

Posted on Nov 20, 2009

jsanamane

  • 64 Answers

SOURCE: my 1988 chevy beretta v6

its common for chevy vehicles-you have a problem with your crank positioning sensor,our 06' colorado does that- sensor maybe $50.00,look into that sensor..
hope that helps you-good luck!

Posted on Nov 05, 2010

calgaryhomes

Sam

  • 120 Answers

SOURCE: 99 durango, stalled out when I was driving down

On the fuel rail there is a shrader valv, push it down while some one is cranking and see if you have any fuel, if not then I suspect that the fuel pump is dead.

Posted on Jul 21, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

88' sundance efi stalls at stop lights and signs, also when having to slow down to make a turn. seems to run fine all other times.


Remove and clean IAC ( idle air control ) motor and port it comes out of with throttle body spray cleaner , then retry it. If that cures it for a while and it starts to act up again, replace the IAC motor.motor1258_10.gif

Sep 20, 2011 | 1987 Plymouth Sundance

1 Answer

My 1988 chevy beretta v6 2.8 liter runs fine starts nice, when it gets running and gets hot sometimes it will stall out not all the time but just sometimes, and when i have been drivin it for a while say...


its common for chevy vehicles-you have a problem with your crank positioning sensor,our 06' colorado does that- sensor maybe $50.00,look into that sensor..
hope that helps you-good luck!

Nov 05, 2010 | 1988 Chevrolet Beretta

2 Answers

87 Plymouth Sundance keeps stalling!


If you take the air intake hose off at the throttle body inlet, and when it won't start, try spraying WD-40 into the front of throttle body, with plate open, and then try again. If it starts for a second or 2, it's fuel related problem. Try that and let me know the results, and get back to me. Use the WD-40 same as you would quick start spray. What engine is in that , 6 cyl, or 4 cyl. ?

Nov 12, 2009 | 1987 Plymouth Sundance

1 Answer

Fuel pressure intermittently drops causing sputter and die.


check for 12v constant at your fuel pump if you are not getting that replace your relay.
if you are getting 12 volts at your fuel pump the fuel pump is possible to run tuel it gets warm then shut down to a lower rpm I would then replace the fuel pump

Oct 10, 2009 | 1994 Dodge Ram

1 Answer

Stall as soon as oil light came on..92 sundance


I don't think a 92 sundance will shut the fuel pump down when the oil pressure is low, but it might. Can you get it to run on carb cleaner. If it is oil pressure, the car should start then run a few seconds and die. Have you checked the timing belt? If it broke the distributor will stop turning which would stop the oil pump.

Jun 05, 2009 | 1992 Plymouth Sundance

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...