SOURCE: where is the crank sensor located on a 99 jeep cherokee
Your crank sensor is located between the engine and the trans. From the pass. side. look behind the engine and you'll find a wiring harness that goes to a sensor that is installed in the bell housing A 10mm bolt holds it in place. If you're replacing the sensor, make sure you look at the wiring harness that goes to it. The harness likes to come apart.
SOURCE: 2005 Subaru Baja Crank Shaft Position Sensor
is there a problem using e10 ethonal in a subaru impreza wrx 2003
SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?
the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?
SOURCE: location/testing of crank sensor 1995 jeep wrangler
Should be on the bellhousing on the drivers side just where you need rubber arms to reach it.Should have no continuity between b&c terminals (check with ohmeter) Harness plug is usually on the drivers side between the master cyl and the back of the engine (unless someone moved it)
SOURCE: jeep wrangelr Crank Position Sensor
wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.
66 views
Usually answered in minutes!
×