Noticing humming from fuse panel and harness under the hood my thought is deteriated wires may be shorted out. It is a 96 Grand Cherokee?
SOURCE: Replacing 1993 Jeep Grand Cherokee wiring harness in driver's door
watch the vaccuum lines very carefully. they are hell to track down and replace. other than that, just make sure you get everything correct. jeeps freak out when you screw up even just 1
SOURCE: I have a 96 Jeep Grand Cherokee and had a
I have the book in my hand, but inside the lid of the fusebox itself is a diagram of which fuse is which.
Where can I email a copy of page 215 of the book?
[email protected]
SOURCE: 1999 jeep grand cherokee heater fan quit. 40amp
the blower motor resistor is bad replace it and it will work good as new the resistor is located in the same heater box as the blower motor mounted on the outside of the heater box follow the wirring from the blower motor to find it or just simply buy the part and match it up
SOURCE: 96 jeep grand cherokee
we have also had this problem this week over the last few days, on the passenger side of transmission we found the neutral safety switch just before the catalytic converter wiring harness and wires were melted and frayed so check there also
SOURCE: my jeep 2004 grand cherokee the door locks and
i believe you will find that the ground wire for all the doors is broken you can check it by removing the rubber bellows in the driver door jam that is where it usually breaks its the thick black wire, repair it by installing two thinner wires in between so it has more flex, and it wont break again.
Please see my tip at http://www.fixya.com/cars/r5821173-doesnt_car_start_gasoline_engines . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.
232 views
Usually answered in minutes!
×