SOURCE: Blown main fuse on 2003 mazda protege 5.
There are two bolts on the side of the fuse itself. Under the fuse box on each side. Unbolt those and it will come out.
SOURCE: where is the blower motor resistor on a 2002 mazda protege?
just remove the glove box and its right behind it just take the white pug out and the two phillips screws to remove the resistor out, replace with the new one and cool off!!!! Hope this helps
SOURCE: 2001 Mazda Protege cooling fan or thermostat
I am realizing that the cooling fan in this car is very important. It has two in case you didn't notice. The driver side fan motor is bad in mine and the only result is poor air conditioner performance in stop and go traffic. It's fine at high speeds. I would think the thermostat is likely the culprit in your case, but if the fans are not working at all, you should get those replaced. The motors may be bad in both, which could definitely cause overheating. I've been researching prices and you should be able to get the parts for less than $100 each and installation is just a couple of bolts on each assembly.
SOURCE: Mazda protege rear strut replacement 02
they're underneath the plastic deck cover in the back, where the speakers are. -just a few plastic fasteners and the wire connector for the rear light, and it'll pop right off. -just did it myself this weekend
SOURCE: valve clearence settings mazda protege 2003
This is for a non turboNew adjustment shim =Removed shim thickness+ measured valve clearance- STANDARD VALVE CLEARANCE (0.26 mm or 0.010 inch)
63 views
Usually answered in minutes!
×