SOURCE: 1989 Buick Century
Have someone to press down on the front, middle part of the hood, above where the latch mechanism is located while you pull on the inside latch release. While holding the latch release pulled, have the person pressing down to let go of the hood.
SOmetimes to much tension on the release spring causes the hood to bind and will not allow the release to work properly.
SOURCE: HOOD RELEASE CABLE CAME UNDONE AT THE LATCH ASSEMBLY. HOW DO I OPEN IT WITH OUT THE CABLE WORKING?
remove front grille then you have to fiddle about with the catch it is quite tedious but the only way or take to a dealrship
SOURCE: engine hood wont open hood pull handle pulls out but wont release
Try pulling on the hood release, while someone else lifts the hood. If this doesn't work. You can access the underside of the hood release by taking the front grille out. If you look closely you'll see the retainer screws that can be removed from the front. Once the grille is out or loosened enougt to get your hand in behind, you can release the hood latch from the underside with a screwdriver and then repair the hood latch after you've opened it.
SOURCE: hood will not open when you pull release handle
There might be several problems:
1. Cabling to and from handle and latch is loose or stretched (normal wear) or broken. Replace and/or adjust
2. The latch is dirty or bent/deformed. Clean and lubricate
3. The latch needs adjusting, lubricating. Clean and lubricate
4. Misalignment of hood due to: wear, or slight bump/accident, nudge. Check for alighnment!
Try having someone pull up the hood while you pull the lever. This is a quickie only; then do items mentioned above...
119 views
Usually answered in minutes!
×