Code p0700 w a H02S on a chryslar sebring - Cars & Trucks

means using wrong old and lame scan tools
p0700 means transmission error GENERAL( uSA fed code)
means others are there but not using 2008 or newer scan tools
means missing all those better DTC errors
get the car scanned in a real shop using real tools
no kidding.

missing p17xx codes and more.

https://www.700r4transmissionhq.com/p0700-chrysler-sebring/

P0700
P0700 OBD II Trouble Code Transmission Control System Malfunction...
p0732
P0732 OBD II Trouble Code Gear 2 Incorrect Ratio YourMechanic Advice
p0733
P0733 OBD II Trouble Code Gear 3 Incorrect Ratio YourMechanic Advice

P0562 - system voltage low (speed control and idle control system)

P0700 - transmission control system malfunction

P0499 - evaporative emission system vent valve control circuit high

H02S heater control circuit high Bank 2 sensor 2.

2006 Sebring Convertible - Transmission Codes - P0700, P0720, & P0731....
2006 Sebring Convertible, started while driving around town - transmission did not want to shift and CEL came on. Stopped, checked transmission fluid and looked for anything obvious. All fluids good, nothing obvious. About 5 miles from home, drove back roughly 15-20 mph. Only other issue that had came to mind was the alternator had been making a whining noise for some time, probably 3 months or so - had mentioned to wife that we should replace it before it completely failed. Found one reference on the internet that the alternator could cause weird electrical conditions / interference if bad - leaking voltage back through ground. Thinking the alternator likely needed replacing anyway, I replaced it and cleared codes - all issues were solved - no more alternator whining and all transmission issues resolved. Replaced alternator on Sept 9, 2019 today is Sept 12, 2021 and still going - I think its safe to say the alternator was the culprit in this instance.

These are tricky codes as they apply to the transmission and the safety features to prevent the vehicle from moving when its not supposed to move. There are many things that could cause these codes and they could also be codes tripped erroneously. To clear these codes remove negative cable from battery. Touch the negative cable to positive for one second. Reattach negative cable to battery. Start vehicle,....drive away happy........OR you will need to replace parts. Shift solenoid more than likely.

If you need further help, reach me via phone at https://www.6ya.com/expert/lloyd_4256582adacd68ee

Code P0700 just means the trans computer has a code. You need to have the trans computer read to get the trans code p0034 the rubber turbo hose to the inlet manifold which had a small split in it causing it to loose pressure these codes will not make your car not start check battery to see if its dead again does the engine turn over at all when you put battery back in car is terminals tight

p0700
Transmission control system malfunction

try this site it might be of some use..its 2000 on...

http://www.troublecodes.net/chrysler/00avseb.shtml