How do you replace 2006 Freestar R&R vent window motors

Pull the fuse and put it back in, first. Then pull the plug on the back of the IP and put it back in. It is intermittent. These will usually fix the problem... Corrosion.

Rear Quarter Window Actuator - Right (A20)
Behind the right rear interior body panel
Rear Quarter Window Actuator - Left (A20)
Behind the left rear interior body panel
Rear Quarter Window Inoperative

1

Did you review the rear quarter window description and operation?
Go to Step 2
Go to Symptoms - Body Rear End

2

Verify that the rear quarter windows are inoperative.
Do the rear quarter windows operate normally?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
Go to Step 3

3

Are both rear quarter windows inoperative?
Go to Step 4 yes
Go to Step 6 no

4

1. Turn OFF the ignition.
2. Disconnect the rear quarter window switch.
3. Turn ON the ignition, with the engine OFF.
4. Probe the accessory voltage circuit of the rear quarter window switch harness connector with a test lamp that is connected to a good ground.

Does the test lamp illuminate?
yes Go to Step 5
no Go to Step 7

5

Connect a test lamp between the accessory voltage circuit of the rear quarter window switch harness connector and the ground circuit of the rear quarter window switch harness connector.
Does the test lamp illuminate?
Go to Step 8
Go to Step 10

6

1. Turn OFF the ignition.
2. Disconnect the appropriate rear quarter window actuator.
3. Turn ON the ignition, with the engine OFF.
4. Connect a test lamp between the power window motor rear vents open control circuit of the rear quarter window actuator harness connector and the power window motor rear vents close control circuit of the rear quarter window actuator harness connector.
5. Activate the rear quarter window switch to the Open and Close positions.

Does the test lamp illuminate?
yes Go to Step 9
no Go to Step 11

6

1. Turn OFF the ignition.
2. Disconnect the appropriate rear quarter window actuator.
3. Turn ON the ignition, with the engine OFF.
4. Connect a test lamp between the power window motor rear vents open control circuit of the rear quarter window actuator harness connector and the power window motor rear vents close control circuit of the rear quarter window actuator harness connector.
5. Activate the rear quarter window switch to the Open and Close positions.

Does the test lamp illuminate?
yes Go to Step 9
no Go to Step 11

7

Test the accessory voltage circuit for an open or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 14
Go to Retained Accessory Power (RAP) Inoperative in Computer/Integrating Systems

8

Inspect for poor connections at the harness connector of the rear quarter window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
yes Go to Step 14
no Go to Step 12

9

Inspect for poor connections at the harness connector of the appropriate rear quarter window actuator. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
yes Go to Step 14
no Go to Step 13

10

Repair the open in the ground circuit of the rear quarter window switch. Refer to Wiring Repairs and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 14
--

11

Repair the open in the appropriate power window motor rear vents control circuit. Refer to Wiring Repairs and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 14
--

12

Replace the rear quarter window switch. Refer to Quarter Window Switch Replacement .
Did you complete the replacement?
Go to Step 14
--

13

Replace the appropriate rear quarter window actuator. Refer to Body Side Window Actuator Replacement .
Did you complete the replacement?
Go to Step 14
--

14

Operate the system in order to verify the repair.
Did you correct the condition?
System OK
Go to Step 2

If it has dual climate control, then something is wrong with either a vent/blend door motor problem, broken door inside the plenum or heater/A-C box, try to self test system to see what is going on causing this problem. Hopefully there is not a pen/pencil blocking the door so it will not close.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_2496c4f07ad24453

If more than one window is not working, it could be the controller in the door, or lack of power to that side of the van.
Have you checked the window switch for power and ground ?

you may have to have the GEM module checked out as I believe it controls heater control operation.

maybe try this link
http://www.edmunds.com/ford/freestar/2004/consumer-discussions.html

A slow window with intermittent operation is generally a symptom that the window switch is carboning up and about to stop working all together ( the contacts will get too bad to operate ).

There is a thread at F150online.com in the how to forum that has pictures on how to dissemble the switch and clean the contacts with an eraser or emery cloth.

http://www.f150online.com/forums/articles-how-tos/414955-how-fix-defective-window-switch.html

My 2006 did this already on the driver's side.

If the switch is clean, it could be the motor or wiring to the motor, but the most likely issue is the contacts in the switch.

Alternate to this is just to replace the switch, these are ~ 68.00 + S/H online or ~ 87.00 at a local dealer.

check your fuses

before that try a contact cleaner spray

Hi, both power windows are not working, I would start with the fuse, check in your owner manual for the location. Please let me know how you make out.

Cheers