I have a 2000 Odyssey with a six-disc CD player. Radio works but the player has stopped. I believe there is a SECOND fuse for the CD player (not in the passenger-side fuse box). Any ideas?

If its a 6 disk cd system the cd tray is wedge causing the cd option to not work. Most of the time one of the cd slipped out of its position causing it to wedge

see a relative link
http://www.hondacarforum.com/honda-3/22348-2000-honda-civic-radio-error-code-problem.html

if on off works its not fuse , some radio have a slide behind buttons some have rubber buttons .on diodes ,take off panel and clean ,

well might a fusuable link on the back of the radio that might need to repplaced.

Subject: Radio With Six Disc CD Changer Does Not Recognize Loaded CD And Displays An "INITIALIZING" Message, CD Will Not Play, CD Cannot Be Ejected, Or Disc Icon Does Not Illuminate (Reprogram Radio)
Models:
2005-2006 Chevrolet Avalanche, Suburban, Tahoe
2005-2007 Chevrolet Colorado, Express, Silverado Classic, TrailBlazer
2005-2006 GMC Yukon, Yukon XL
2005-2007 GMC Canyon, Envoy, Savana, Sierra Classic
2005-2006 HUMMER H2 with Six Disc CD Changer Equipped Audio System (RPO UC6)
Condition
Some customers may comment on any of the following conditions:
• The CD loaded in the radio will not play.
• The CD loaded in the radio will not eject.
• The disc icon on the radio will not illuminate.
• The radio displays an "INITIALIZING" message for approximately 30 seconds after vehicle start up.
Important: Do not attempt to play CDs with paper labels on them in this CD player. The labels may warp or wrinkle and jam the CD player mechanism. Refer to the Compact Disc Care and Cleaning procedure (Document ID# 1656123) in SI for more information.
Technicians are to reprogram the radio with new operating software using the following procedure:
1. If the radio has a CD(s)2008 General will be necessary to reset the radio and remove them
before the radio is reprogrammed. Remove and reinstall the radio fuse to reset the radio and then eject the CD(s). If cycling the power to the radio does not allow the CD(s) to be removed, the radio may have another failure that will not be corrected by the reprogramming procedure that follows. Refer to the Diagnostic Starting Point - Entertainment procedure in SI to begin your diagnosis of this failure to eject CDs concern before reprogramming the radio.
2. Reprogram the radio using the Service Programming System (SPS) with the latest software available on TIS2WEB. Refer to the SPS procedures and the Radio Programming and Set procedure in SI for more information. As always make sure your Tech 2® is updated with the latest software version.
3. Verify proper operation of the radio and make sure that all CDs can be ejected.

Hope helps (remember to rate this).

there is a problem with the laser or the disc motor is worn out and not spinning at the required 600 rpm

Try the basic first, go and pick up one of Maxell CD-AUTO Automotive CD Lens Cleaner and see if this might solve the problems. When a factory cd player give an error basically it become inoperative/faulty and it will be difficult fix it your self unless you some some electronics background and the have the radio schematic. Its not worth fixing by sending to your local electronics repair shop unless you attached to it. All electronics tend to fail soon or later and some has better luck than others. After market radio will be as good or better than your stock radio. Keep in mind, the radio in your vehicle is mass produced cheap, saving the auto manufacture allot of money. You can look on ebay which list from 80 bucks to 140 dollars for stock replacement radio fairly cheap and I don't recommend getting it from the dealer which they will charge you 500-600 bucks for new one.
Hope that help some

ur vehicle needs a new stereo unit..