2006 Hyundai Tucson Logo

Related Topics:

Jacob Mosito Posted on May 27, 2017

Abs brake system of Hyundai Tucson 2006 model

5 Related Answers

Anonymous

  • 67 Answers
  • Posted on Mar 07, 2009

SOURCE: 2006 Hyundai Sonata brake switche

hyundai bumper to bumper warranty is 5yrs 60k miles with 100k powertrain for original owner. unless you have an extended warranty it is not covered. there is actually a tsb for adjustment on the brake lamp switch

Ad

Anonymous

  • 67 Answers
  • Posted on Apr 09, 2009

SOURCE: change brakes on a 05 hyundai tucson

rear pad replacement is basically the same as front. 14mm bolts holding caliper and mount on hub then the piston just pushes in

Anonymous

  • 64 Answers
  • Posted on Apr 17, 2010

SOURCE: hyundai tucson 2006 start overheating out of

Waterpump, seems like a likley culprit. Your Ac compressor belt runs over your water pump. when the ac is on it puts more load on your engine , your water pump may be defected and not able to handle the extra load.

johnjohn2

Johnny Brown

  • 5763 Answers
  • Posted on May 20, 2010

SOURCE: I have a 2006 Hyundai Tucson and the a/c will not

this is right, this uses motors,the selector motor is located on the driverside of the heater/ac box, there are a few of these motors you will need to test them by operating the controls until you spot the one that doesnt move,these motors are on the box one or two on passengerside and one or two more on the driveside, all depending on if you have daul zones or not good luck this can get tricky locating the right one and testing it.

ghost45

PAUL MC G

  • 1280 Answers
  • Posted on Feb 16, 2011

SOURCE: where is backup light switch located on 2006

You didn't say if this vehicle was Automatic Transaxle or Manual Transaxle. No need

here are two photos: One is Manual, the other is Automatic. The manual trans has a separate switch (all by itself), however, the automatic (of both the 4 cylinder and 6 cylinder) use the trans range switch to provide power to the back up lamps

ghost45_6.jpg


ghost45_7.jpg


Hope this helps

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Hi, I'd like to ask where the abs speed wheel is located. Where is the plug under the hood of the car ? hyundai tucson 2.0 crdi 4wd 2006

their at each wheel the small black wire runs by the brake line behind the rotor -need to take wheel off
0helpful
1answer

2006 Hyundai Tucson 4wd 2.0L experiencing brake fluid not flowing through the left front wheel line, brakes locked up

if it is locked up on the front left side only , it sounds like the caliper is stuck , remove caliper and see if you can squeeze it in with a large c clamp .. may be hard to remove if it is stuck on caliper . replace with rebuilt if it is locked up then rebleed
0helpful
1answer

How do I fix the front brake line on a Hyundai Tucson 2006

Probably best to buy the exact replacement line first...break fittings loose first spray with PB Blaster, If corroded, you may need to use vise-grips on both nuts...you MUST bleed your brake system completely after changing any lines or connections. Hope this helps.
0helpful
1answer
0helpful
1answer

Abs brake system

Best case scenario bad vacuum pressure to the brake booster. Worst case bad abs control module or valve body/motor the abs system works by add and removing hydraulic pressure through valves and electric motor. Try using block off plugs at the master cylinder( remove lines plug outlets at master cylinder) check if brake pedal position and pressure is good(if there is no change problem is master cylinder or brake booster/ vacuum) if plugging at master cylinder solved issue repeat procedure at abs valve body after reinstalling lines from master cylinder if your problem returns your issue is in the abs valve body if plugging at the abs solves problem reconnect at the valve body bleed each line one by one testing between each line until you find the problem
0helpful
1answer

The taillights on my Hyundai 2005 Tucson won't go out when I turn offthe ignition

be looking at the brake pedal switch and also control module tho I think that gets tested at the dewaler..
0helpful
2answers
0helpful
2answers
Not finding what you are looking for?

258 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...