1998 olds intrigue where is the coolant sensor
SOURCE: crank position sensor location
you will need to remove the starter to gain acess to the ckp sensor. once you remove the starter look on the engine block and you will see the sensor. The only problem with doing this repair yourself is that you will not be able to preform the crankshaft position variation learn procedure with out a factory scan tool. The vehicle may crank an run, but the timing advance curves will be wrong so the vehicle will probably cut off every time you remove your foot from the gas pedal. Hope this info helps!
I’m happy to assist further over the phone at https://www.6ya.com/expert/jonathan_3a3c556b4b17d1d2
SOURCE: 1998 olds intrigue trouble code p0171
I have a dianogstic machine and the code you were given indicates that the system is too lean. (Bank 1) Were you go from here i'm not too sure. Steve
SOURCE: 1999 Olds Alero 3400 motor -- location of Crankshaft sensor
Welcome to fixya. If you need anything else go to www.collisionrepairadvice.com here is the location.
On the lower rear of the engine (LA1) for the 7x
and for the 24x
On the lower rear of the engine (LA1
Testimonial: "Got it Thank You!!! Actually my problem was a bad fuel pump in the gas tank."
SOURCE: need to drain coolant from 1998 Olds Intrigue.
COOLANT CHANGEON THE RADIATOR (LOWER DRIVERS SIDE FACING THE MOTOR) THERE IS A PLASTIC LIKE PLUG THAT YOU TURN COUNTER CLOCKWISE ABOUT 3/4 OF A TURN, THEN YOU CAN PULL IT OUT ABOUT 1/2 AN INCH THIS WILL DRAIN THE RADIATOR, THEN YOU CAN PUSH THE PLUG BACK IN AND TURN IT UNTIL YOU FEEL IT LOCK BACK IN PLACE. REFILL RADIATOR WITH 3 PARTS COOLANT TO 1 PART WATER.
1998-'99 Intrigues equipped with the 3800 engine have a specific process for replacing antifreeze. It is somewhat of a lengthy process and you should refer to your owners manual for doing this. After you empty and flush your system with water (garden hose), only fill the system with green 50/50 antifreeze, NOT Dex-Cool. Avoid Dex-Cool. If you bring your Intrigue to a shop to get serviced, make sure and inform whoever doing repairs and/or leave a note (clearly visible) to NOT use Dex-Cool if they're doing any work pertaining to cooling system.
SOURCE: Trying to replace the crankshaft position sensor
Hello suewagner.
The crank sensor is mounted above the starter motor on the firewall side of the engine. The sensor picks up the signal direct off of the crankshaft through a machined hole in the engine block.
I have removed them without dropping the starter but learned that in most cases it is easier to drop the starter down to access it.
Here is a diagram for you.
There you are, hope this helps you.
Take care,
KL
154 views
Usually answered in minutes!
×