1998 Buick Regal Logo

Related Topics:

J
Joseph sandoval Posted on May 04, 2017

I don't know how to use the multi meter reader to bypass the wires from the antitheft in a 1998 Buick regal what do I do

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Mar 07, 2009

SOURCE: STEREO WIRE CODES DIAGRAM FO A 1998 BUICK CENTURY

need codes to hook up radio to 1999 buick century

Ad

Anonymous

  • 202 Answers
  • Posted on Mar 26, 2009

SOURCE: locked radio 1998 buick regal

You will need the radio code. The dealer will have to provide this information unless it is written in your owners manual.

Anonymous

  • 82 Answers
  • Posted on May 08, 2009

SOURCE: 87 regal ignition switch wiring diagram

Thick wires at IGN SW .... Red(s) - supply power from the battery to the IGN switch ... Pink - ignition supply ... Orange - Accessory power ... Purple most RWD sometimes (Yellow most FWD) - Starter .. Did I miss any? It's been a while The thin wires on the IGN swich are for key sense and VATS (if applicable)

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Aug 30, 2009

SOURCE: water on passenger side floor of Buick Regal

U need to clear the AC condensation drain, crawl under the car on the passenger side and near the base of the engine firewall u will find a drain pipe, (about 3/4") clear t and the water will stop going on the passenger floor.

Anonymous

  • 170 Answers
  • Posted on Sep 20, 2009

SOURCE: Ignition Security

Here's a video link http://www.youtube.com/watch?v=AKfn7J9CeZM

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

I dont know how many miles are on my 1998 buick Regal LS cause as you can it says error and dont know why???

get the OBD codes read and will have a reset function , must be a dealer quality OBD reader
0helpful
1answer

1998 Buick Regal the windows stopped working on all 4 doors. Ocasionally I would press the widow switch and they would work. I replaced the main switch on the drivers door and they still don't wor

ALL the windows share a common ground, this could be your problem. The ground wire originates at the driver's switch and goes back through the harness to the door, and into the cabin where I think the black ground wire may ground on a frame or bracket in the left kick panel. Just after it comes in from the door. You'd have to look behind the kick panel (foot well) covering to look for the ground screw. There could be a couple other ground wires there too. Or take your meter and check the integrity of the ground wire at the switch. Either use the ohm function or do a voltage drop test to check the ground.
1helpful
1answer

94 buick regal wiring diagram for ignition to starter

It is possible for the antitheft system to disable the starter from being activated by the ignition. This link explains

http://vatspasslockpasskeysecurityhelp.yolasite.com/
0helpful
1answer

My 1995 Buick Regal is not starting, checked everything and it will start past the coil, how do you check the neutral park switch without replacing it? I have checked all the other starting componants, It...

Remove the connectors and probe them with an ohmmeter.
Connect one lead of your meter to the terminal with the yellow wire and the other lead to the terminal with the purple wire. Set the parking brake and shift the transmission through the gears. When in park or neutral, the meter should read zero ohms.

0900c152800680d2-jnh1p0frnkt3q2fbcpfimq4v-1-1.gif
0helpful
2answers

My '98 Buick Regal will not start. It makes one click noise. The battery is fine, and jumping it doesn't work. Any idea what the problem is?

YOU NEED TO CHECK THE BATTERY IF IT HAS CAPS TAKE THEM OFF AND CHECK WATER LEVEL BUT ALL BATTERYS DON;T HAVE CAPS YOU CAN USE A VOLT METER TO CKECK OUT PUT CHCEK + TO -SHOULD BE AT LEAST 12 VOLTS THEN HAVE SOMEONE ELSE TURN KEY TRYING TO START IF THE VOLTAGE DROPS BATTERY IS NG BE CAREFUL BATTERYS CAN EXPLODE
0helpful
1answer

Service engine light comes on, replaced gas cap, how long does it take for the sensor to reset it self?

usually you need to unhook the battery for about ten or 15 minutes. if it's an antitheft radio make sure you know the code and how to enter it. also it won't reset if replacing the gas cap didn't fix the issue.
0helpful
1answer

My buick regal doesnt send signal from pcm to crank relay.

check pcm with a scanner to see if crank and cam sensor are working.
Not finding what you are looking for?

171 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...