SOURCE: removal of rear brake drum 2002 ford escape
make sure handbrake is off take wheel off hit the drum with a mallet not steel,as it will brake,hit on outter diametter face of drum, try and rotate as you twist off
SOURCE: Blower motor stopped working.
ok to the left of the steering wheel by brake pedal remove fuse panel and look for no. 3 location blower relay after that your going to look for no. 8 blower fuse 40amps after that look for no. 28 its a 10amp fuse this is blower coil relay but if you have puddle lights that fuse is good also runs them !! Hope this helps you out !! Rick from nwi auto acdelco & ford parts dealer !
SOURCE: ford escape 2002 firing order
V6 1-4-2-5-3-6 back bank pasenger side right to left cylinders 1 2 3
front bank passenger side right to left 4-5-6
4 cly 1-3-4-2
SOURCE: 2002 ford escape tie rod squeaks
My outer tie rod did the same thing when just out of warranty. I could tell it was "bad" by putting my hand on the tie rod while someone else turned the steering a little and I could easily feel the vibration.
Check the other side to feel the difference. Tie rods don't cost that much, if you can replace it yourself, and take a chance on foregoing the wheel alignment. Maybe a $150? job at the shop.
In my case, a tie rod was not readily available. I verified that it was a good joint; no shake or rattle. Then I squirted a little WD40 inside the boot, and put it back together. 70,000 miles later, the new tie rod is still on my shelf waiting for the squeak to return.
SOURCE: How do you replace the EGR on a 2002 ford escape?
To replace the the spark plugs on the V6, you'll need to remove the intake manifold. There is a coil on top of each plug (COP). Check this website for info:
http://www.escape-central.com/1forum/showthread.php?threadid=32550&referrerid=11756
The same link will also show the R&R of the EGR valve.
1,031 views
Usually answered in minutes!
×