SOURCE: call stalls
You should also check the crank positioning sensior to make sure it is not loose.
SOURCE: 2002 Hyundai Accent Problem
first thing i need to know is did the timing belt break?
second is are you sure you aligned the timing marks and after the belt tensioner was tight you rechecked to make sure the timing stayed where you had it.
next step would be a compression check to if a valve was bent whenchanging the belt
i have seen this happen and this engine is an interferance engine.
later paul
SOURCE: 2002 hyundai accent codes p1529 and p0734
P1529 means nothing more than the TCM (transmission control module) has
requested that the ECM (engine control module) turn on the check engine
lamp.
P0734 basically indicates that your transmission is slipping.
You need to take this car to an authorized repair center for hyundai cars. Replacing the filter and fluid on the transmission might save this transmission but I would be willing to bet that a total transmission rebuild is in order.
Good Luck
SOURCE: hyundai accent stops running after heats up
I had the exact smae problem and threw aaway a ton of money on bad "guesses" at what was wrong. The actual fix was replacing the crank shaft position sensor for 50 or 60 bucks. Swapped out bad for good and cars has run great every day since.
SOURCE: timing belt on my 2002 hyundai accent 1.6 liter 4cyl
DID THE BELT BREAK AND THEN IT WAS CHANGED. If so then you may have bent valve. IF NOT then vehicle may be timed wrong. Here is a diagram of your timing marks, http://www.2carpros.com/car_repair_information/tec_info/2002/hyundai/accent/2002_hyundai_accent_timing_belt_diagram_marks.htm contact if you need more help. Thanks for using FIX YA
105 views
Usually answered in minutes!
×