How to change the head gasket in a1999 Chrysler Sebring

SOURCE: White smoke when I start!

Well, it sounds like it could either be a head gasket or a cracked head. (sorry for being so blunt with possible bad news)

The reason that you can't find a "diy" manual is because your car is too new and the manuals have not been released yet.

For the most part, you can look at one of the older versions of the manuals and the information will probably be the same for your car. They only change when something is added or taken off the cars. The torque specs should be the same for the like engine sizes.

I hope this helps

SOURCE: replacing headlight bulbs on a 2006 chrysler sebring

Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.

SOURCE: how to change head lamp to Chrysler Sebring

Remove 2 screws holding the headlamp and pull forward.

Testimonial: "Kiitos, mutta olisi ollut hyödyksi saada tietää, että ruuvit ovat 7 mm:siä. Toiseksi neuvo tuli vasta kun ongelma oli jo aikaa sitten ratkaistu. Mukavaa silti saada palautetta. Terv. Matti"

SOURCE: 2001 chrysler sebring leaking water beneath

Hi,

This is called the water pump weep passage which is a sign that your seal in the water pump has failed.

You need to replace the water pump.

paulmacintyre

• 3218 Answers
• Posted on Apr 05, 2015

SOURCE: How to change and replace valve cover gaskets in a 2004 Chrysler Sebring Convertible 2.7L DOHC V6

You first have to remove the ignition coils or plug wires and then remove the bolts holding the cover to the cylinder head. Discard old gasket. Clean gasket channel of any oil and install new gasket to cover taking care during assembly not to disturb gasket when placing cover back on cylinder head. The rear gasket is much harder to change as the upper plenum must be removed to access this cover. You should have some knowledge of engines if you are going to atempt this repair on your own