SOURCE: what is the firing order
1-2-3-4-5-6 firing order( belt end looking toward trans axle ) first on left (1) (2) on right(3)on left and so on
SOURCE: how to change the serpentine belt on a lumina euro 3.1??
I found on my 92 lumina 3.1 the easiest way to change the belt is to have two people handy (you and a helper) push the belt tensioner (which is more in the middle of the belt system, its the only thing that has give when pressure is applied) down (which will loosen the belt) have your partner slip the belt off the altenator (which should be on the very top of the belt system on the passenger side) and just pay attention to the way the belt is routed as you remove it, put the new one on (routed correctly) push the tensioner again have your partner slip it back over the altenator....and you have a new belt on with no tools :)
just pay good attention to the routing of the belt, and i also think there is a black cover over the belt which needs to be removed before the old belt can be taken off (if you dont see it at first you will find it) it has 3 bolts i think and also a diagram of the routing....
TIP: the tensioner will take some muscle to move down, and yes the belt is running over it....
SOURCE: Ignition switch won't turn and car won't go into gear 1995 Chevy
Make sure you don't have the steering wheel locked. If the key still won't turn then you will have to replace the ignition lock cylinder. The gear shifter on any car should not move unless key is turned.
SOURCE: removal of 1976 chevy truck ignition switch
need a special tool to remove the locking plate behind steering wheel then pull turn signal switch back a little then remove screw that keeps lock cylinder in place
SOURCE: 1993 chevy lumina euro 3.1 skips and sputters when going uphill
Computer. Or chip inside bad. its on passennger side under fuses
194 views
Usually answered in minutes!
×