Transmission filter on 2006 Hyundai Tucson need to be changed do you have to change filter

steven martin

• 117 Answers
• Posted on Apr 09, 2009

SOURCE: Hyundai Tucson

The transmission filter is inside the transmission. You have to drain out the oil and remove the transmission pan and gasket. The filter is made of metal guaze and is screwed/bolted to the underneath of the valve body.

SOURCE: how to change ATF in 2006 hyundai sonata?

IF YOU ARE NOT FAMILLIOR WITH IT TAKE IT TO A SHOP.There is one and it is a very messy job you have to take trans pan off to drain fluid (tricky) and the filter is under the pan.

SOURCE: Replace Hyundai Tucson cabin filter

hi. here is the link to the step by step.

http://blog.aggregatedintelligence.com/2007/12/hyundai-santa-fe-cabin-air-filter.html

SOURCE: HOW TO CHANGE FUEL FILTER ON 2008 HYUNDAI TUCSON

instructions

Things You'll Need:
Fuel-line disconnect tool
Rag
New gasket
New fuel pump
Flat head screwdriver
Ratchet and socket
The assistance of a friend (only when you are ready to remove the back seat)
Rubber hose plugs
Two adjustable wrenches
1

Locate the fuse panel under the hood of your vehicle, then open it and remove the fuel pump fuse with your hands.
2

Start your car and allow the fuel system to depressurize by allowing the car to idle until the engine dies.
3

Reinstall the fuse, then disconnect the battery with a ratchet and socket. Drain the gas from the gas tank with a siphoning kit.
4

Remove the back seat by unbolting the base with a ratchet and socket and lifting the seat out with your hands. The bolts are located on either side of the seat near the base. You will also need the assistance of another person to lift the seat out safely.
5

Remove the wiring harness by gently pulling it from the connector, and detach the rubber grommet with a flat head screwdriver. Unbolt the fuel tank cover with a ratchet and socket, remove it with your hands, pull the wires through the grommet, detach the fuel line hoses with a fuel-line disconnect tool, and lift the hoses out. Cap the hoses with rubber hose plugs.
6

Reach directly into the gas tank, then remove the fuel filter using two adjustable wrenches, placing one on either side of the fuel filter. You will recognize the fuel filter by its filtering paper cartridges.
7

Install the new filter, then follow the previous steps in reverse to complete the installation. Refill your gas take when finished

Testimonial: "thaks Question: why I need a new fuel pump ? its necesary to change fuel pump too ? thanks again"

PAUL MC G

• 1280 Answers
• Posted on Feb 16, 2011

SOURCE: where is backup light switch located on 2006

You didn't say if this vehicle was Automatic Transaxle or Manual Transaxle. No need

here are two photos: One is Manual, the other is Automatic. The manual trans has a separate switch (all by itself), however, the automatic (of both the 4 cylinder and 6 cylinder) use the trans range switch to provide power to the back up lamps







Hope this helps