My 95 grand Cherokee back fires and stalls when acceleration

SOURCE: jeep grand cherokee 95 fuel pump takes long time to start ,

First install a fuel pressure tester on the fuel rail and check the pressure during crank. It should be about 30 psi.If the pressure is not good then it could be a bad fuel pump relay or fuel pump itself (in the tank).
If the fuel pump pressure is good then you could have a bad crank sensor.

SOURCE: what other yrear transmissions will fit in the 95 grand cherokee with the 6cyl besides 95?

42RE: The 42RE four speed automatic transmission was used in 1993.3 to 1998 Jeep Grand Cherokees with 4.0L engines. 46RH: The 46RH four speed automatic transmission was used in 1993 to 1995 Jeep Grand Cherokees with 5.2L engines.

SOURCE: 95 grand cherokee oil pressure switch

Use a deep well socket and extension, it lives by the distributor.

ZJ Limited

• 17989 Answers
• Posted on Sep 01, 2009

SOURCE: 1993 jeep grand cherokee, choking, pulling then stalled,

Check:
- Fresh Air Intake Hose: Clogged or Damaged FreshAir Intake Hose.
- Carburetor: Worn, Faulty or Damaged Carburetor.
- Mass Air Flow Sensor: Damaged, Loose, or Faulty Mass Air Flow Sensor or Circuit.
- EGR Valve: EGR Valve Sticking Open/Leaking.
- Idle Air Control Valve: IAC Valve Sticking or Faulty.

Good luck.

SOURCE: firing order for 95 jeep grand cherokee 6

I'm assuming the "6" is for the 6-Cylinder....

For the 4.0L (6-Cyl):
Firing Order:
1-5-3-6-2-4
Cylinders:
(back of engine)
.........6
.........5
.........4
.........3
.........2
.........1
(front of engine)
Distributor:
.....(back)
.................(+)-screw
.....5.....3
1...............6
.....4......2
(+)-screw
......(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!