Have a Citroen dispatch van 2005 fan belt has broken need a diagram to put new one on has only 6 pullies on it can any one help

Question edited for clarity.

Check out the link and the images tab.

https://www.google.com/search?q=citroen+dispatch+replace+gear+linkage+diagram

..

Question edited for clarity, and spelling 'citron' (French for 'lemon', how apt), to 'Citroen'.
Question moved to maker category.

It would be easier to fix the doors you have on there, unless the bodywork panels are damaged or in worse shape than the ones on the old van. It can only be the hinges alignment, or the locking mechanism. You could take them from the old doors. To remove doors, you just undo the screws, and if connected, any wiring.

Help in the link

https://www.google.com/search?q=citroen+dispatch+panel+van+replace+rear+door

..

the filter hides inside a housing with a hex nut molded into it.

https://www.google.com/search?q=peugeot+traveller+oil+filter+location

and images. Modern filters are often hidden underneath and behind the engine.

https://www.google.com/search?q=citroen+dispatch+change+oil+filter&tbm=isch&ved=2ahUKEwjmwN2xrK34AhWPlXIEHc9KA14Q2-cCegQIABAA&oq=citroen+dispatch+change+oil+filter&gs_lcp=CgNpbWcQAzIECCMQJ1DFCliEH2DcLGgAcAB4AIABhQGIAcMIkgEDNC42mAEAoAEBqgELZ3dzLXdpei1pbWfAAQE&sclient=img&ei=J7WoYqaRNI-rytMPz5WN8AU&bih=937&biw=1920&rlz=1C1QJDB_enCA643CA644

..

It's in the heater box near the blower motor

here try this .....

citroen dispatch van 1 9 timing marks Google Search

There is a spring loaded tension pully that needs to be depressed. I believe is has a 1/2 inch square socket female end on the front of tension pully that you can use a 18" or 20" breaker-bar to get leverage to reduce the tension. Reduce the tension remove belt and just reverse the process to install new belt.

How do l wire a second hand tow bar to my Citroen dispatch please

Fit new power steering belt

the main digram for all drive belt ( flat belt ) is . first look to all pully make drowing out side with small paper 3 or 4 or 5 or 6 .....pully the main drive pully is crank . the end of you belt round the pully must be more than 180?? angl. alternator angl. more than 180 .compressor or water pump anther pully try use same digram .guide pully and belt tensioner no need to put angl .

which is standard or the best motor oil for HDI?