How do spark plugs cable inserted in an automatic toyota camry model 1997

6ya staff

• 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

Posted on Jan 02, 2017

Alan Conner

• 359 Answers

SOURCE: toyota camry 1997 3.0 v-6 code p0446

That code is for the evaporative emmisions system. Here is a link to an open forum you can go to, this will help you understand what it is, and why. The vehicle on the site is a van, but the code, and parts involved are one in the same, so don't worry about the difference in vehicle. The van is a toyota, and this is the information on the p0446 code. Hope this helps you.
http://steampunkworkshop.com/toyota-sienna-evaporative-canister-and-svs-valve-repair

Posted on Mar 08, 2009

SOURCE: removing a drive axle from

if you already have the ball joint dissconnect and the axle out of the steering knuckle just pry out the axle at the transaxle assembly. if it doesnt wont to come out try pushing it in and pry it out vary qiuck pull on the pry bar but they are only held in place with a colasable c-clip just giver.it will come dont worry it wont break

Posted on Mar 22, 2009

SOURCE: change spark plugs on 2007 Toyota Camry

In servicing the spark plug . If the owner will be the one to change the spark plug then. the owner should locate the spark plugs . then prepare the equipments that is going to be used to change spark plug .First disconnect the spark plug cable to the spark pug . Then use the equipment to take the spark plug off to the engine. The spark plug should be twisted counter clock wise using the equipment to remove the spark plug.Then replace the spark plug.In returning the spark plug ,using the equipment you have to twist the spark plug clock wise . Then set the distributor shaft turn it according to the proper firing order that will be set to the spark plug if it is 1,3,4,2. Then the distributor shaft mark will be on 1.If 2,3,4,1 then the distributor shaft mark will be on 2. Then connect the spark plug cable , after connecting the owner have to test start the car so that to if it back fires .If it back fires then the owner have to repeat again the setting of the firing order of the spark plug until it will not back fires.If the owner don't have time to do the job in servicing or changing spark plug then the owner have to go to a car mechanic and let them change the spark plug.

Posted on Sep 26, 2009

Bill Schilz

• 2049 Answers

SOURCE: I need a spark plug wiring diagram for my 1997

Here's the diagram you asked for...

Posted on Mar 12, 2010

SOURCE: tune up 1998 toyota camry LE V6

cant get to the back spark plugs on a 1998 v6 toyota camry

Posted on Apr 14, 2010